The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced the during antenna cord sub-assembly removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After the power switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is driven
Use the same procedure for RHD and LHD vehicles.
The following procedure is for LHD vehicles.
55401E
1.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
55086
2.REMOVE NO. 3 HEATER TO REGISTER DUCT SUB-ASSEMBLY (for LHD)
55084E
3.REMOVE NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY (for RHD)
86101
4.REMOVE ANTENNA CORD SUB-ASSEMBLY (for LHD)
Disengage the clamps to remove the antenna cord sub-assembly.
| *A | w/ USB Audio System | *B | w/ Manual (SOS) Switch |
w/ Manual (SOS) Switch:
Disconnect the connector.
86101
5.REMOVE ANTENNA CORD SUB-ASSEMBLY (for RHD)
Disengage the clamps to remove the antenna cord sub-assembly.
| *A | w/ USB Audio System | - | - |
63311C
6.REMOVE ROOF HEADLINING
86101J
7.REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY
for Type A:
Remove each adhesive tape from the roof headlining.
|
Adhesive Tape |
|
Front |
Remove the No. 2 antenna cord sub-assembly from the roof headlining.
for Type B:
Remove each adhesive tape from the roof headlining.
|
Adhesive Tape |
|
Front |
Remove the No. 2 antenna cord sub-assembly from the roof headlining.
for Type C:
Remove each adhesive tape from the roof headlining.
|
Adhesive Tape |
|
Front |
Remove the No. 2 antenna cord sub-assembly from the roof headlining.
86101D
8.REMOVE NO. 3 ANTENNA CORD SUB-ASSEMBLY
for Glass Antenna Type:
Disconnect the connector of the No. 4 antenna cord sub-assembly.
Disconnect the connector.
Disengage the clamps.
w/ Manual (SOS) Switch:
| *a | Guide |
| *b | Clamp |
Disconnect the connector of the floor wire.
Remove the bolt.
Disengage the clamp and guide to remove the No. 3 antenna cord sub-assembly.
w/o Manual (SOS) Switch:
| *a | Guide |
| *b | Clamp |
Remove the bolt.
Disengage the clamp and guide to remove the No. 3 antenna cord sub-assembly.
64790B
9.REMOVE BACK DOOR TRIM UPPER PANEL ASSEMBLY (for Glass Antenna Type)
86101Q
10.REMOVE NO. 4 ANTENNA CORD SUB-ASSEMBLY (for Glass Antenna Type)
| *a | Grommet |
Disconnect the connector.
Disengage the clamp and 2 grommets to remove the No. 4 antenna cord sub-assembly.