Home › Vehicle Interior › METER / GAUGE / DISPLAY › COMBINATION METER › from 2020.08
RM32K0E _58 Vehicle Interior _062180 METER / GAUGE / DISPLAY _0303184 COMBINATION METER A

METER / GAUGE / DISPLAY  COMBINATION METER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 83100 1.INSTALL COMBINATION METER ASSEMBLY

a.

Connect the 2 connectors to install the combination meter assembly.


b.
E357885

Engage the guides and clips.


c.

Install the 2 screws.


Hide 55414C 2.INSTALL STARTER SWITCH BEZEL (for RHD with Entry and Start System)

Hide 55012A 3.INSTALL NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

Hide 55410C 4.INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Hide 55470 5.INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY

Hide 55404D 6.INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 7.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 8. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART