The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the front seat outer belt assembly removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Wear protective gloves. Sharp areas on the parts may injure your hands.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
1.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
for 2ZR-FXE:
Click hereGeneral>MAINTENANCE>2ZR-FXE AUXILIARY BATTERY>REMOVAL
for M20A-FXS:
Click hereGeneral>MAINTENANCE>M20A-FXS AUXILIARY BATTERY>REMOVAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
67914
2.REMOVE FRONT DOOR SCUFF PLATE
62312B
3.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
Disconnect the front door opening trim weatherstrip.
67918A
4.REMOVE REAR DOOR SCUFF PLATE
62332A
5.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
Disconnect the rear door opening trim weatherstrip.
73233
6.REMOVE LAP BELT OUTER ANCHOR COVER
|
Remove in this Direction |
Disengage the claws and guide to remove the lap belt outer anchor cover as shown in the illustration.
73220
7.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY
Remove the bolt to disconnect the floor anchor of the front seat outer belt assembly.
62414A
8.REMOVE CENTER PILLAR LOWER GARNISH
62420A
9.REMOVE CENTER PILLAR GARNISH ASSEMBLY
73220
10.REMOVE FRONT SEAT OUTER BELT ASSEMBLY
Remove the nut to disconnect the shoulder anchor of the front seat outer belt assembly.
for TMMT Made:
| *a | Protective Tape |
| *b | Locking Button |
Using a screwdriver with its tip wrapped in protective tape, pull out the locking button to release the lock to disconnect the pretensioner connector as shown in the illustration.
except TMMT Made:
| *a | Protective Tape |
| *b | Locking Button |
Using a screwdriver with its tip wrapped in protective tape, pull out the locking button to release the lock to disconnect the pretensioner connector as shown in the illustration.
Remove the bolt.
Disengage the guides to remove the front seat outer belt assembly.
73200A
11.REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
Remove the 2 bolts.
Disengage the guide to remove the front shoulder belt anchor adjuster assembly.