Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM
RM32H0E _55 Steering _059605 POWER ASSIST SYSTEMS _0292301 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1521  Short in Motor Circuit  C1522  Power Supply Sensor  C1523  Current Deviation Excessive  C1528  Motor Rotation Angle Sensor  C1531  ECU Malfunction  C1532  ECU Malfunction  C1533  Temperature Sensor Circuit is Low or High  C1534  EEPROM  C1555  Motor Relay Welding Failure  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Return-to-normal Condition Note
C1521 Short in Motor Circuit Motor overcurrent Power steering ECU assembly EPS warning light: Comes on Ignition switch ON again -
C1522 Power Supply Sensor Motor current sensor malfunction Power steering ECU assembly EPS warning light: Comes on Ignition switch ON again -
C1523 Current Deviation Excessive Excessively large current deviation Power steering ECU assembly EPS warning light: Comes on Ignition switch ON again -
C1528 Motor Rotation Angle Sensor Motor rotation angle sensor malfunction Power steering ECU assembly EPS warning light: Comes on Ignition switch ON again -
C1531 ECU Malfunction ECU internal malfunction
(CPU malfunction)
Power steering ECU assembly EPS warning light: Comes on The ECU judges the system has returned to normal or the ignition switch is turned ON again -
C1532 ECU Malfunction ECU internal malfunction
(Peripheral circuit malfunction)
Power steering ECU assembly EPS warning light: Comes on Ignition switch ON again -
C1533 Temperature Sensor Circuit is Low or High ECU internal malfunction
(Substrate temperature sensor malfunction)
Power steering ECU assembly EPS warning light: Comes on Ignition switch ON again -
C1534 EEPROM ECU internal malfunction
(EEPROM error)
Power steering ECU assembly EPS warning light: Comes on Ignition switch ON again -
C1555 Motor Relay Welding Failure Motor relay circuit malfunction Power steering ECU assembly EPS Warning Light: Comes on Ignition switch ON again -

CAUTION / NOTICE / HINT

NOTICE:

If the power steering ECU assembly has been replaced, perform assist map writing and torque sensor zero point calibration.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION


PROCEDURE

1.CHECK FOR DTC
a.

Clear the DTCs.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR

Chassis > EMPS > Clear DTCs
50002 142

b.

Check for DTCs.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR

Chassis > EMPS > Trouble Codes
50001 142

Result:
Result Proceed to
DTCs other than C1521, C1522, C1523, C1528, C1531, C1532, C1533, C1534 or C1555 are not output. (for LHD) A
DTCs other than C1521, C1522, C1523, C1528, C1531, C1532, C1533, C1534 or C1555 are not output. (for RHD) B
DTCs other than C1521, C1522, C1523, C1528, C1531, C1532, C1533, C1534 or C1555 are output. C



A

REPLACE POWER STEERING ECU ASSEMBLY

B

REPLACE POWER STEERING ECU ASSEMBLY

C