| C1511
|
Torque Sensor1
|
Torque sensor malfunction
|
EPS warning light: Comes on
|
The ECU judges the system has returned to normal or the ignition switch ON again
|
-
|
|
| C1512
|
Torque Sensor2
|
Torque sensor malfunction
|
EPS warning light: Comes on
|
The ECU judges the system has returned to normal or the ignition switch ON again
|
-
|
|
| C1513
|
Torque Sensor Deviation Excessive
|
Torque sensor malfunction
|
EPS warning light: Comes on
|
The ECU judges the system has returned to normal or the ignition switch ON again
|
-
|
|
| C1514
|
Torque Sensor Power Supply Voltage
|
Torque sensor malfunction
|
EPS warning light: Comes on
|
Ignition switch ON again
|
-
|
|
| C1515
|
Torque Sensor Zero Point Adjustment Undone
|
This DTC is stored when torque sensor zero point calibration has not been performed.
|
EPS warning light: Comes on
|
Zero point calibration is performed or the ignition switch is turned ON again
|
There is no malfunction if this DTC is not output again after performing zero point calibration.
|
|
| C1516
|
Torque Sensor Zero Point Adjustment Incomplete
|
Torque sensor zero point calibration is incomplete due to the steering wheel being touched during calibration.
|
EPS warning light: Comes on
|
Ignition switch ON again
|
There is no malfunction if this DTC is not output again after clearing the DTC and torque sensor calibration value, and performing zero point calibration.
|
|
| C1517
|
Torque Hold
|
Torque sensor malfunction
|
EPS warning light: Comes on
|
Ignition switch ON again
|
-
|
|
| C1521
|
Short in Motor Circuit
|
Motor overcurrent
|
EPS warning light: Comes on
|
Ignition switch ON again
|
-
|
|
| C1522
|
Power Supply Sensor
|
Motor current sensor malfunction
|
EPS warning light: Comes on
|
Ignition switch ON again
|
-
|
|
| C1523
|
Current Deviation Excessive
|
Excessively large current deviation
|
EPS warning light: Comes on
|
Ignition switch ON again
|
-
|
|
| C1528
|
Motor Rotation Angle Sensor
|
Motor rotation angle sensor malfunction
|
EPS warning light: Comes on
|
Ignition switch ON again
|
-
|
|
| C1531
|
ECU Malfunction
|
ECU internal malfunction
(CPU malfunction)
|
EPS warning light: Comes on
|
The ECU judges the system has returned to normal or the ignition switch is turned ON again
|
-
|
|
| C1532
|
ECU Malfunction
|
ECU internal malfunction
(Peripheral circuit malfunction)
|
EPS warning light: Comes on
|
Ignition switch ON again
|
-
|
|
| C1533
|
Temperature Sensor Circuit is Low or High
|
ECU internal malfunction
(Substrate temperature sensor malfunction)
|
EPS warning light: Comes on
|
Ignition switch ON again
|
-
|
|
| C1534
|
EEPROM
|
ECU internal malfunction
(EEPROM error)
|
EPS warning light: Comes on
|
Ignition switch ON again
|
-
|
|
| C1541
|
Vehicle Speed Signal
|
Vehicle speed signals via CAN communication are cut off for 3 seconds or more.
|
EPS warning light: Comes on
|
The ECU judges the system has returned to normal or the ignition switch is turned ON again
|
-
|
|
| C1551
|
IG Power Supply Voltage
|
Open or short in IG power source circuit with ignition switch ON
|
EPS warning light: Comes on
|
The ECU judges the system has returned to normal or the ignition switch is turned ON again
|
-
|
|
| C1552
|
PIG Power Supply Voltage
|
PIG power source circuit malfunction
|
EPS warning light: Comes on
|
Ignition switch ON again
|
-
|
|
| C1554
|
Power Supply Relay Failure
|
Power source relay circuit malfunction
|
EPS warning light: Comes on
|
Ignition switch ON again
|
-
|
|
| C1555
|
Motor Relay Welding Failure
|
Motor relay circuit malfunction
|
EPS Warning Light: Comes on
|
Ignition switch ON again
|
-
|
|
| C1567
|
Error in Matching of ECUs
|
There is a system recognition error
|
EPS warning light: Comes on
|
Ignition switch ON again
|
-
|
|
| C1581
|
Assist Map Number Un-Writing
|
Assist map not written in power steering ECU assembly
|
EPS warning light: Comes on
|
Assist Map Writing is performed or the ignition switch is turned ON again
|
-
|
|
| C1582
|
Assist Map Number Mismatch
|
Assist map number mismatch
|
EPS warning light: Does not come on
|
Assist Map Writing is performed or the ignition switch is turned ON again
|
-
|
|
| U0100
|
Lost Communication With ECM/PCM "A"
|
Lost communication with ECM
|
EPS warning light: Does not come on
|
The ECU judges the system has returned to normal or the ignition switch is turned ON again
|
-
|
|
| U0129
|
Lost Communication with Brake System Control Module
|
Lost communication with skid control ECU (brake actuator assembly)
|
EPS warning light: Comes on
|
The ECU judges the system has returned to normal or the ignition switch is turned ON again
|
-
|
|
| U023A
|
Lost Communication with Front Camera Module
|
Lost communication with forward recognition camera
|
EPS warning light: Does not come on
|
The ECU judges the system has returned to normal or the ignition switch is turned ON again
|
w/ Toyota Safety Sense
|
|
| U1110
|
Lost Communication with Clearance Sonar Module
|
Lost communication with clearance warning ECU assembly
|
EPS warning light: Does not come on
|
The ECU judges the system has returned to normal or the ignition switch is turned ON again
|
w/ Simple Intelligent Parking Assist System
|
|