31410
1.INSTALL CLUTCH MASTER CYLINDER ASSEMBLY
Install the clutch master cylinder assembly to the body with the 2 nuts.
31410
2.CONNECT CLUTCH MASTER CYLINDER ASSEMBLY
31481
3.CONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE
| *a | Torque Wrench Fulcrum Length |
Using a 10 mm union nut wrench, connect the clutch master cylinder to flexible hose tube to the clutch master cylinder assembly.
Do not kink or damage the clutch master cylinder to flexible hose tube.
Do not allow any foreign matter such as dirt or dust to enter the clutch master cylinder to flexible hose tube from the connecting part.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a union nut wrench (fulcrum length of 22 mm (0.866 in.)) + torque wrench (fulcrum length of 162 mm (6.38 in.)): 13.4 N*m (137 kgf*cm, 10 ft.*lbf)
31434
4.CONNECT CLUTCH RESERVOIR TUBE
| *a | View A |
| *b | Top of Vehicle |
| *c | Left of Vehicle |
| *d | Paint Mark |
| *e | 90° |
Connect the clutch reservoir tube to the clutch master cylinder assembly and slide the hose clip to secure it.
Perform the installation with the clutch reservoir tube and hose clip at the correct angle.
5.FILL RESERVOIR WITH BRAKE FLUID
6.BLEED CLUTCH LINE
7.INSPECT FOR BRAKE FLUID LEAK
8.INSPECT BRAKE FLUID LEVEL IN RESERVOIR
9.INSPECT CLUTCH PEDAL
87211
10.INSTALL NO. 1 AIR DUCT