Home › Vehicle Interior › HEATING / AIR CONDITIONING › BLOWER UNIT (for VALEO Made) › 2016.10–2019.09
RM32H0E _58 Vehicle Interior _059841 HEATING / AIR CONDITIONING _0293720 BLOWER UNIT(for VALEO Made) A

HEATING / AIR CONDITIONING  BLOWER UNIT(for VALEO Made)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the blower unit removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Pre-collision system
Initialize back door lock Power door lock control system (Click here)
Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system (Click here)
No. 1 Blower Damper Servo Sub-assembly Initialize servo motor (Air conditioning system) DTCs are stored (Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIMPLE INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION

*2: w/ Stop and start system

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

Make sure to perform initialization after replacing the No. 1 blower damper servo sub-assembly. If initialization is not performed, the air conditioner unit assembly will not perform properly as the air conditioning amplifier assembly will not be able to recognize the position of the No. 1 blower damper servo sub-assembly.


Hide 82143 5.REMOVE NO. 3 INSTRUMENT PANEL WIRE (w/ PTC Heater)

Hide 87130D 6.REMOVE BLOWER ASSEMBLY

a.

for LHD:

i.
I112385

Disconnect the connector.


ii.

Disengage the guide.


iii.
I112386

Remove the 2 screws.


iv.

Disengage the guides to remove the blower assembly from the air conditioning radiator assembly.



b.

for RHD:

i.
I112387

Disconnect the connector.


ii.

Disengage the guide.


iii.
I112388

Remove the 2 screws.


iv.

Disengage the guides to remove the blower assembly from the air conditioning radiator assembly.