The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the engine coolant temperature sensor removal/installation are shown below.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DRAIN ENGINE COOLANT
28800
3.REMOVE BATTERY
11212
4.REMOVE NO. 2 CYLINDER HEAD COVER
17705
5.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE
16571C
6.DISCONNECT NO. 1 RADIATOR HOSE
89422
7.REMOVE ENGINE COOLANT TEMPERATURE SENSOR
Disconnect the engine coolant temperature sensor connector.
Using SST, remove the engine coolant temperature sensor from the cylinder head sub-assembly.
If the engine coolant temperature sensor has been struck or dropped, replace it.
Remove the gasket from the engine coolant temperature sensor.