Home › Engine / Hybrid System › 8NR-FTS (FUEL) › FUEL PUMP ECU › 2016.10–2019.09
RM32H0E _51 Engine / Hybrid System _059909 8NR-FTS FUEL _0293899 FUEL PUMP ECU A

8NR-FTS FUEL  FUEL PUMP ECU  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel pump control ECU assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Pre-collision system
Initialize back door lock Power door lock control system (Click here)
Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system (Click here)


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Click hereGeneral>MAINTENANCE>8NR-FTS BATTERY>REMOVAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.REMOVE REAR SEATBACK ASSEMBLY LH

Hide 4.REMOVE BENCH TYPE REAR SEAT CUSHION ASSEMBLY

Hide 72693 5.REMOVE REAR SEAT CUSHION LOCK HOOK

Hide 64330D 6.REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Package Tray Trim)

Hide 64910J 7.REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

Hide 58410B 8.REMOVE DECK BOARD ASSEMBLY (w/ Deck Board)

Hide 64777J 9.REMOVE SPARE WHEEL CUSHION (w/ Deck Board)

Hide 64997 10.REMOVE DECK FLOOR BOX LH (w/ Deck Floor Box)

Hide 62332A 11.SEPARATE REAR DOOR OPENING TRIM WEATHERSTRIP LH

a.

Separate the rear door opening trim weatherstrip LH.


Hide 67918A 12.REMOVE REAR DOOR SCUFF PLATE LH

Hide 71304C 13.REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY LH

Hide 62552F 14.REMOVE REAR SEAT SIDE GARNISH LH

Hide 64716D 15.REMOVE DECK TRIM REAR COVER

Hide 81330 16.REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (w/ Luggage Compartment Room Light)

Hide 64740C 17.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

Hide 89570A 18.REMOVE FUEL PUMP CONTROL ECU ASSEMBLY

a.
A393056

Disconnect the fuel pump control ECU assembly connector.


b.

Remove the 2 bolts and fuel pump control ECU assembly.

NOTICE:

Do not reuse the fuel pump control ECU assembly if it has been dropped or subjected to a severe impact.


HINT:

If a malfunction such as pump lock occurs and the fuel pump is damaged, excessive current may be continuously applied to the fuel pump control ECU assembly, damaging its internal parts. Make sure to replace the fuel pump control ECU assembly at the same time when replacing the fuel pump.