Home › Engine / Hybrid System › 8NR-FTS (ENGINE CONTROL) › CAMSHAFT OIL CONTROL VALVE (for Exhaust Side)
RM32H0E _51 Engine / Hybrid System _059353 8NR-FTS ENGINE CONTROL _0295063 CAMSHAFT OIL CONTROL VALVE(for Exhaust Side) A

8NR-FTS ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE(for Exhaust Side)  INSTALLATION  


PROCEDURE

Hide 13523F 1.INSTALL CAMSHAFT TIMING GEAR BOLT

NOTICE:
A378076C10
0.76,1.5 1.188,1.885 1.188,1.885 0.917,1.26 true 1.25,1.823 1.563,1.979 0.313,0.156 10 false *a
*a Identification Mark


There are different types of camshaft timing gear bolts. Make sure to check the identification mark to determine the tightening torque.

Identification Mark
Item Identification Mark
Type A B
Type B G


a.

Make sure that the No. 1 cylinder is at the TDC/compression.

HINT:

Check that the cutout of the camshaft timing gear assembly is at the top and align the timing mark (cutout) of the crankshaft pulley with the protrusion on the timing chain cover assembly.



b.
A352541

Apply engine oil to the areas of the camshaft timing gear bolt shown in the illustration.


c.

While holding the crankshaft pulley, install the camshaft timing gear bolt.

Torque:
for Type A : 120 N*m (1224 kgf*cm, 89 ft.*lbf)
for Type B : 95 N*m (969 kgf*cm, 70 ft.*lbf)

NOTICE:
·

If the camshaft timing gear bolt has been struck or dropped, replace it.

·

Do not use an impact wrench.

·

If there is any abnormal resistance when installing the camshaft timing gear bolt, loosen it and make sure that the No. 1 cylinder is at TDC/compression, and then install the camshaft timing gear bolt again.




Hide 15370 2.INSTALL CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY (for Exhaust Side)

Hide 3.INSPECT FOR ENGINE OIL LEAK

Hide 51443C 4.INSTALL REAR ENGINE UNDER COVER RH

Hide 5.INSTALL FRONT WHEEL RH