1.INSTALL ENGINE WATER PUMP ASSEMBLY
Install a new water pump gasket to the engine water pump assembly.
Be sure to clean the contact surfaces.
Apply adhesive 1324 to the threads of the bolt (C).
| Item | Length |
|---|---|
| Bolt (A) and (D) | 20 mm (0.787 in.) |
| Bolt (B) and (C) | 35 mm (1.38 in.) |
Temporarily install the engine water pump assembly to the timing chain cover assembly with the 6 bolts.
Tighten the bolts within 3 minutes of applying adhesive.
| *a | 12 mm Union Nut Wrench |
| *b | Torque Wrench Fulcrum Length |
Using a 12 mm union nut wrench, tighten the bolt (A).
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a 12 mm union nut wrench (fulcrum length of 20 mm (0.787 in.)) + torque wrench (fulcrum length of 162 mm (6.38 in.)): 18.7 N*m (191 kgf*cm, 14 ft.*lbf)
Tighten the bolt (B), bolt (C) and bolt (D).
16620
2.INSTALL V-RIBBED BELT TENSIONER ASSEMBLY
27020
3.INSTALL GENERATOR ASSEMBLY
for DENSO Made:
Click herePower Source / Network>8NR-FTS (BATTERY / CHARGING)>GENERATOR (for DENSO Made)>INSTALLATION
for VALEO Made:
Click herePower Source / Network>8NR-FTS (BATTERY / CHARGING)>GENERATOR (for VALEO Made)>INSTALLATION
4.ADD ENGINE COOLANT
5.INSPECT FOR COOLANT LEAK
51441
6.INSTALL NO. 1 ENGINE UNDER COVER