Home › Engine / Hybrid System › 8NR-FTS (STARTING) › STARTER (for Denso Made without Stop and Start System) › 2016.10–2019.09
RM32H0E _51 Engine / Hybrid System _060199 8NR-FTS STARTING _0295162 STARTER(for Denso Made without Stop and Start System) A

8NR-FTS STARTING  STARTER(for Denso Made without Stop and Start System)  INSTALLATION  


PROCEDURE

Hide 28100 1.INSTALL STARTER ASSEMBLY

a.

Install the starter assembly to the cylinder block sub-assembly with the 2 bolts.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


b.

Connect the wire harness to the terminal 30 with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


c.

Close the terminal cap.


d.
A394423

Install the terminal cap protector to the terminal cap and secure it with the clamp.


e.

Connect the starter assembly connector.


Hide 2.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Click hereGeneral>MAINTENANCE>8NR-FTS BATTERY>INSTALLATION

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 51441 3.INSTALL NO. 1 ENGINE UNDER COVER