Home › Engine / Hybrid System › 8NR-FTS (STARTING) › STARTER (for Denso Made with Stop and Start System) › 2016.10–2019.09
RM32H0E _51 Engine / Hybrid System _060199 8NR-FTS STARTING _0295163 STARTER(for Denso Made with Stop and Start System) A

8NR-FTS STARTING  STARTER(for Denso Made with Stop and Start System)  INSTALLATION  


PROCEDURE

Hide 28100 1.INSTALL STARTER ASSEMBLY

HINT:

Perform "clear number of starter operations" after replacing a starter assembly.

Click hereEngine / Hybrid System>STOP AND START>STOP AND START SYSTEM>REGISTRATION


a.

Install the starter assembly to the cylinder block sub-assembly with the 2 bolts.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)

NOTICE:

After the starter assembly is replaced, be sure to clear the number of starter operations stored in the engine stop and start ECU.



b.

Connect the wire harness to the terminal 30 with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


c.

Close the terminal cap.


d.
A394420

Install the terminal cap protector to the terminal cap and secure it with the clamp.


e.

Connect the starter assembly connector.


Hide 2.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Click hereGeneral>MAINTENANCE>8NR-FTS BATTERY>INSTALLATION

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 51441 3.INSTALL NO. 1 ENGINE UNDER COVER

Hide 4. PERFORM INITIALIZATION

a.

Perform "clear number of starter operations" after replacing a starter assembly.

Click hereEngine / Hybrid System>STOP AND START>STOP AND START SYSTEM>REGISTRATION