The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the No. 1 cooler thermistor removal/installation are shown below.
*1: When performing learning using the GTS.
*2: w/ Stop and start system
Use the same procedure for RHD and LHD vehicles.
The following procedure is for the LHD vehicles.
87130D
1.REMOVE BLOWER ASSEMBLY
87114B
2.REMOVE HEATER COVER (w/o PTC Heater)
87114L
3.REMOVE NO. 2 HEATER COVER (w/ PTC Heater)
87710G
4.REMOVE QUICK HEATER ASSEMBLY (w/ PTC Heater)
88650N
5.REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY
82210K
6.REMOVE AIR CONDITIONING HARNESS ASSEMBLY
87050C
7.REMOVE NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (for Automatic Air Conditioning System)
87050C
8.REMOVE NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (for Manual Air Conditioning System)
87050D
9.REMOVE NO. 2 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY
88897M
10.REMOVE HEATER PIPE GROMMET
87124B
11.REMOVE HEATER CLAMP
87107A
12.REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY
88515
13.REMOVE COOLER EXPANSION VALVE
87611A
14.REMOVE HEAT EXCHANGER CASE
87102A
15.REMOVE RADIATOR CASE SUB-ASSEMBLY
88501
16.REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
88625
17.REMOVE NO. 1 COOLER THERMISTOR
Remove the No. 1 cooler thermistor.