Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM
RM32H0E _56 Audio / Visual / Telematics _060571 PARK ASSIST / MONITORING _0297206 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  C1AB8  Destination Information Undefined  


DESCRIPTION

This DTC is stored when correct destination information is not sent from the main body ECU (multiplex network body ECU) and destination information cannot be confirmed after a blind spot monitor sensor has been replaced.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1AB8 Destination Information Undefined The blind spot monitor sensor cannot communicate with the main body ECU
·

CAN communication system

·

Main body ECU (multiplex network body ECU)

·

Blind spot monitor sensor LH (Master)

·

Blind spot monitor sensor RH (Slave)



CAUTION / NOTICE / HINT

NOTICE:
·

When checking for DTCs, make sure that the blind spot monitor system is turned on.

·

Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin*1.

*1: w/ Smart Entry and Start System



PROCEDURE

1.CHECK DTC
a.

Check for CAN communication system DTCs.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM

OK:

CAN communication system DTCs are not output.



Result:
Proceed to
OK
NG



OK

2.REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NG

2.REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
a.

Replace the main body ECU (multiplex network body ECU).



Result:
Proceed to
NEXT



NEXT

3.RECHECK DTC
3.RECHECK DTC
a.

Recheck for DTCs and check if the same DTC is output again.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR

Body Electrical > Blind Spot Monitor Master > Trouble Codes
50001 313
Body Electrical > Blind Spot Monitor Slave > Trouble Codes
50001 314

Result:
Result Proceed to
No DTCs are output. A
DTC C1AB8 is output ("Blind Spot Monitor Master"). B
DTC C1AB8 is output ("Blind Spot Monitor Slave"). C



A

END

B

REPLACE BLIND SPOT MONITOR SENSOR LH (MASTER)

C