Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM
RM32H0E _54 Brake _060039 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0294918 VEHICLE STABILITY CONTROL SYSTEM J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  Excessive Brake Pedal Travel (No Fluid Leaks and No Air in System)  


DESCRIPTION

Depending on the malfunction, the skid control ECU (brake actuator assembly) prohibits operation of the vehicle stability control system to protect components and prevent incorrect operation when DTCs are stored.

If the switching solenoid is disabled due to prohibition of the vehicle stability control system, the response of the brake pedal changes and braking performance is reduced.

CAUTION / NOTICE / HINT

NOTICE:

When replacing the skid control ECU (brake actuator assembly), perform system variant learning.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION


PROCEDURE

1.BRAKE PROBLEM CHECK
a.

Check the conditions at the time the problem occurred.

i.

Whether a warning light illuminated or the buzzer sounded.


ii.

Road surface condition when the problem occurred and just before the problem occurred.


iii.

When the problem occurred and how many times the brake pedal was depressed before the problem occurred.


iv.

Frequency of the abnormal brake pedal response.



Result:
Proceed to
NEXT



NEXT

2.CHECK DTC AND FREEZE FRAME DATA
2.CHECK DTC AND FREEZE FRAME DATA
a.

Using the GTS, check DTCs and Freeze Frame Data.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC/EPB > Trouble Codes
50001 105
Result:
Result Proceed to
DTCs are not output. A
DTCs are output. B


HINT:
·

If there are currently no warnings and the brake pedal travel is not excessive, DTCs may have been cleared after the system returned to normal.

·

If the brake pedal response returned to normal and there are currently no warnings, the system is normal.





A

3.CHECK BRAKE PEDAL

B

3.CHECK BRAKE PEDAL
a.

While depressing the brake pedal by hand, check the installation condition of the brake pedal stroke sensor assembly and brake pedal, and check for mechanical malfunctions.


b.

Check and adjust the brake pedal height.

for LHD: Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL (for LHD)>ADJUSTMENT

for RHD: Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL (for RHD)>ADJUSTMENT


Result:
Proceed to
NEXT



NEXT

4.INSPECT BRAKE ACTUATOR ASSEMBLY
4.INSPECT BRAKE ACTUATOR ASSEMBLY
a.

Check the brake actuator assembly.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING

OK:

The brake actuator assembly is normal.



Result:
Result Proceed to
OK A
NG (for LHD) B
NG (for RHD) C



A

B

C