77754B
1.INSTALL CHARCOAL CANISTER OUTLET HOSE
Engage the clamp to install the charcoal canister outlet hose to the fuel tank assembly.
77656B
2.INSTALL NO. 6 FUEL TANK CUSHION
Install 3 new No. 6 fuel tank cushions to the fuel tank assembly.
77100
3.INSTALL FUEL TANK ASSEMBLY
The fuel tank assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the fuel tank assembly may fall off the engine lifter.
Set the fuel tank assembly on an engine lifter.
Using height adjustment attachments and plate lift attachments, keep the fuel tank assembly horizontal.
Using the engine lifter, slowly raise the fuel tank assembly, and then temporarily install the fuel tank assembly with No. 1 fuel tank band sub-assemblies with the 4 bolts.
Tighten the 4 bolts in the order shown in the illustration.
Be careful not to drop the fuel tank assembly.
When installing the fuel tank assembly, tilt it slightly to prevent it from interfering with the surrounding parts.
77209F
4.CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY
Connect the fuel tank main tube sub-assembly to the fuel pipe.
Click hereEngine / Hybrid System>8NR-FTS (FUEL)>FUEL SYSTEM>PRECAUTION
77026A
5.CONNECT NO. 1 FUEL EVAPORATION TUBE SUB-ASSEMBLY
Connect the No. 1 fuel evaporation tube sub-assembly to the fuel pipe.
77213E
6.CONNECT FUEL TANK TO FILLER PIPE HOSE
| *a | Top of Vehicle |
| *b | 120° |
Connect the fuel tank to filler pipe hose to the fuel tank assembly and tighten the clamp to secure it.
Make sure the clamp and fuel tank to filler pipe hose are positioned within the area shown in the illustration.
7.CONNECT FUEL TANK BREATHER TUBE
Connect the fuel tank breather tube to the fuel tank filler pipe sub-assembly.
Click hereEngine / Hybrid System>8NR-FTS (FUEL)>FUEL SYSTEM>PRECAUTION
77754B
8.CONNECT CHARCOAL CANISTER OUTLET HOSE
| *a | 120° |
| *b | Paint Mark |
| *c | Top of Vehicle |
Connect the charcoal canister outlet hose to the fuel tank filler pipe sub-assembly and slide the hose clip to secure it.
77641A
9.INSTALL NO. 1 FUEL TANK PROTECTOR
Install the No. 1 fuel tank protector to the fuel tank assembly with the 4 clips.
77642A
10.INSTALL NO. 2 FUEL TANK PROTECTOR
Install the No. 2 fuel tank protector to the fuel tank assembly with the nut and 4 clips.
57628C
11.INSTALL REAR FLOOR SIDE MEMBER COVER LH
Install the rear floor side member cover LH with the clip (B).
Install the 2 bolts and 2 clips (A).
57627A
12.INSTALL REAR FLOOR SIDE MEMBER COVER RH
Install the rear floor side member cover RH with the clip (B).
Install the 2 bolts and 2 clips (A).
37100
13.INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
14.INSTALL EXHAUST PIPE ASSEMBLY
77010
15.INSTALL FUEL TANK VENT TUBE ASSEMBLY
77020A
16.INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
17.ADD FUEL