Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE BOOSTER (for LHD) › 2016.10–2019.09
RM32H0E _54 Brake _060040 BRAKE SYSTEM (OTHER) _0298579 BRAKE BOOSTER(for LHD) A

BRAKE SYSTEM (OTHER)  BRAKE BOOSTER(for LHD)  INSTALLATION  


PROCEDURE

Hide 44785 1.INSTALL BRAKE BOOSTER GASKET

a.

Install a new brake booster gasket to the brake booster assembly.


Hide 44610 2.INSTALL BRAKE BOOSTER ASSEMBLY

a.

Temporarily install the brake booster assembly to the vehicle body.

NOTICE:

Do not apply excessive force to the brake lines or refrigerant lines.



b.

Temporarily install the clevis lock nut and brake master cylinder push rod clevis to the brake booster assembly.

NOTICE:

Fully tighten the clevis lock nut when adjusting the brake pedal height.



c.
C366914N01
0.656,1.5 0.813,1.698 0.156,0.198 10 true 1 2.417,0.531 2.573,0.729 0.156,0.198 10 true 2 0.688,0.49 0.844,0.688 0.156,0.198 10 true 3 2.469,1.448 2.625,1.646 0.156,0.198 10 true 4

Install the 4 nuts to secure the brake booster assembly.

Torque:
12.7 N*m (130 kgf*cm, 9 ft.*lbf)

NOTICE:

Tighten the 4 nuts in the order shown in the illustration.



d.

Remove the protective tape.


e.

Engage the 2 clamps to install the fuel pipe to the fuel pipe clamp.


f.

Engage the clamp to install a new No. 2 brake tube clamp to the vehicle body.


g.

Engage the 5 clamps to install the No. 2 brake tube clamp to the brake tubes.


h.

Engage the 5 clamps to install a new No. 1 brake tube clamp to the brake tubes.


i.

w/ Stop and Start System:

i.

Connect the vacuum sensor connector.



j.

w/ Vacuum Warning Switch:

i.

Connect the vacuum warning switch connector.



Hide 3.CONNECT CHECK VALVE TO CONNECTOR TUBE HOSE

a.

Connect the check valve to connector tube hose to the brake booster assembly and slide the clip to secure it.


Hide 55225 4.INSTALL DASH PANEL HEAT INSULATOR

a.
C366880N01
1.771,0.104 2.021,0.323 0.25,0.219 10 true (A) 3.01,0.25 3.26,0.469 0.25,0.219 10 true (A)

Temporarily install dash panel heat insulator to the vehicle body with the 2 nuts (A).


b.
C366902N01
1.885,1.802 2.156,2.021 0.271,0.219 10 true (B)

Install the nut (B).

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


c.

Tighten the 2 nuts (A).

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


Hide 51441 5.INSTALL NO. 1 ENGINE UNDER COVER

Hide 47264A 6.INSTALL PUSH ROD PIN

Hide 47101A 7.INSTALL BRAKE PEDAL RETURN SPRING

Hide 47201 8.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY

Hide 9.INSPECT AND ADJUST BRAKE PEDAL