Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System with Top-mounted Air Conditioner Pressure Sensor)
RM32H0E _58 Vehicle Interior _059841 HEATING / AIR CONDITIONING _0298707 AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System with Top-mounted Air Conditioner Pressure Sensor) C

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System with Top-mounted Air Conditioner Pressure Sensor)  B1413  Evaporator Temperature Sensor Circuit  


DESCRIPTION

The No. 1 cooler thermistor (evaporator temperature sensor) is installed to the evaporator in the air conditioner unit to detect the temperature of the cooled air that has passed through the evaporator, which is used to control the air conditioning system. It sends signals to the air conditioning amplifier assembly. The resistance of the No. 1 cooler thermistor (evaporator temperature sensor) changes in accordance with the temperature of the cooled air that has passed through the evaporator. As the temperature decreases, the resistance increases. As the temperature increases, the resistance decreases.

The air conditioning amplifier assembly applies voltage (5 V) to the No. 1 cooler thermistor (evaporator temperature sensor) and reads voltage changes as the resistance of the No. 1 cooler thermistor (evaporator temperature sensor) changes. This sensor is used for frost prevention.

DTC No. Detection Item DTC Detection Condition Trouble Area Memory
B1413 Evaporator Temperature Sensor Circuit Any of the following conditions is met:
·

Open in No. 1 cooler thermistor (evaporator temperature sensor) circuit

·

Short in No. 1 cooler thermistor (evaporator temperature sensor) circuit


·

No. 1 cooler thermistor (evaporator temperature sensor)

·

Air conditioning harness assembly (heater radiator unit sub- assembly)

·

Air conditioning amplifier assembly


Memorized
(4 seconds or more)*

*: The air conditioning amplifier assembly stores this DTC if the malfunction has occurred for the period of time indicated in the brackets.


DTC Detection Conditions
Vehicle Condition
Pattern 1 Pattern 2
Diagnosis Condition Ignition switch ON ○ ○
Malfunction Status Open in No. 1 cooler thermistor (evaporator temperature sensor) circuit ○ -
Short in No. 1 cooler thermistor (evaporator temperature sensor) circuit - ○
Detection Time 4 seconds or more 4 seconds or more
Number of Trips 1 trip 1 trip

HINT:

DTC will be output when conditions for either of the patterns in the table above are met.


WIRING DIAGRAM

E361468E01
1.729,0.656 1.885,0.854 0.156,0.198 10 false 1 1.729,1.135 1.885,1.333 0.156,0.198 10 false 2 4.76,1.156 4.979,1.365 0.219,0.208 10 false 39 4.76,0.667 4.979,0.875 0.219,0.208 10 false 38 5.01,1.156 5.427,1.396 0.417,0.24 10 false SGA 5,0.667 5.417,0.906 0.417,0.24 10 false TEA 5.875,0.365 6.292,0.604 0.417,0.24 10 false 5V 6.458,0.771 6.875,1.01 0.417,0.24 10 false AD 4.885,1.792 5.302,2.031 0.417,0.24 10 false F7A 2.396,1.792 4.635,2.583 2.24,0.792 10 false Air Conditioning Harness Assembly (Heater Radiator Unit Sub-assembly) 0.063,1.729 0.479,1.969 0.417,0.24 10 false ev 4.865,1.979 7.156,2.26 2.292,0.281 10 false Air Conditioning Amplifier Assembly 0.052,1.917 2.24,2.5 2.188,0.583 10 false No. 1 Cooler Thermistor (Evaporator Temperature Sensor)

PROCEDURE

1.READ VALUE USING GTS (EVAPORATOR FIN THERMISTOR)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Air Conditioner / Data List.


e.

Read the Data List according to the display on the GTS.

Body Electrical > Air Conditioner > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Evaporator Fin Thermistor No. 1 cooler thermistor (evaporator temperature sensor) Min.: -29.70°C (-21.46°F)
Max.: 59.55°C (139.19°F)
Actual evaporator temperature displayed -
Body Electrical > Air Conditioner > Data List
Tester Display
Evaporator Fin Thermistor
50003 121 3
OK:

The display is as specified in the normal condition column.



Result:
Result Proceed to
NG A
OK (When troubleshooting according to Problem Symptoms Table) B
OK (When troubleshooting according to the DTC) C



A

2.INSPECT NO. 1 COOLER THERMISTOR (EVAPORATOR TEMPERATURE SENSOR)

B

C

4.CHECK FOR DTC
2.INSPECT NO. 1 COOLER THERMISTOR (EVAPORATOR TEMPERATURE SENSOR)
a.

Remove the No. 1 cooler thermistor (evaporator temperature sensor).

Click hereVehicle Interior>HEATING / AIR CONDITIONING>FRONT EVAPORATOR TEMPERATURE SENSOR (for VALEO Made)>REMOVAL


b.

Inspect the No. 1 cooler thermistor (evaporator temperature sensor).

Click hereVehicle Interior>HEATING / AIR CONDITIONING>FRONT EVAPORATOR TEMPERATURE SENSOR (for VALEO Made)>INSPECTION


Result:
Proceed to
OK
NG



OK

3.INSPECT AIR CONDITIONING HARNESS ASSEMBLY (HEATER RADIATOR UNIT SUB-ASSEMBLY)

NG

REPLACE NO. 1 COOLER THERMISTOR (EVAPORATOR TEMPERATURE SENSOR)

3.INSPECT AIR CONDITIONING HARNESS ASSEMBLY (HEATER RADIATOR UNIT SUB-ASSEMBLY)
a.

Remove the air conditioning harness assembly (heater radiator unit sub-assembly)

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING UNIT (for VALEO Made)>DISASSEMBLY


b.
E361414C03
1.458,0.177 1.917,0.448 0.458,0.271 1.073,2.802 1.438,3.073 0.365,0.271 2.177,1.927 2.542,1.458 true 2.875,1.865 2.625,1.458 true 2.042,1.99 2.5,2.188 0.458,0.198 10 false TEA 2.781,1.896 3.24,2.094 0.458,0.198 10 false SGA 1.542,0.229 2,0.427 0.458,0.198 10 false F74 0.198,0.135 0.656,0.333 0.458,0.198 10 false *a 0.76,2.385 1.219,2.583 0.458,0.198 10 false *b 1.177,2.823 1.635,3.021 0.458,0.198 10 false ev
*a Front view of wire harness connector
(to Air Conditioning Amplifier Assembly)
*b Front view of wire harness connector
(to No. 1 Cooler Thermistor (Evaporator Temperature Sensor))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F74-38 (TEA) - ev-1 Always Below 1 Ω
F74-39 (SGA) - ev-2 Always Below 1 Ω
F74-38 (TEA) - F74-39 (SGA) Always 10 kΩ or higher
F74-39 (SGA) or ev-2 - Body ground Always 10 kΩ or higher
F74-38 (TEA) or ev-1 - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

REPLACE AIR CONDITIONING HARNESS ASSEMBLY (HEATER RADIATOR UNIT SUB-ASSEMBLY)

4.CHECK FOR DTC


Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

B

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY