The engine control unit and transmission control unit are located inside the ECM. The engine control unit intercommunicates with the transmission control ECU via CAN communication.
If there is a problem in this intercommunication, the ECM stores this DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory | Note |
|---|---|---|---|---|---|---|
| U010087 | Lost Communication with ECM/PCM "A" Missing Message | All conditions are met for 1.25 seconds or more (1-trip detection logic):
·
The ignition switch is ON and battery voltage is 9.5 V or higher ·
There is no communication between the engine control unit and transmission control unit. |
ECM | Does not come on | DTC stored | SAE Code:
U0100 |
After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.
Check that the battery voltage is 9.5 V or more.
Turn the ignition switch to ON.
Check for DTCs again.
Click hereDrivetrain>EC69 (MANUAL TRANSMISSION / TRANSAXLE)>MANUAL TRANSAXLE SYSTEM>DTC CHECK / CLEAR
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Enter the following menus: Powertrain / Transmission / Trouble Codes.
Check if DTCs are output.
| Result | Proceed to |
|---|---|
| Only DTC U010087 is output | A |
| DTC U010087 and other DTCs are output | B |
A
B
Replace the ECM.
Click hereEngine / Hybrid System>8NR-FTS (ENGINE CONTROL)>ECM>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT