Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Manual Air Conditioning System)
RM32H0E _58 Vehicle Interior _059841 HEATING / AIR CONDITIONING _0298709 AIR CONDITIONING SYSTEM(for Manual Air Conditioning System) C

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)  B1451  Compressor Solenoid Circuit  


DESCRIPTION

In this circuit, the compressor with pulley assembly (compressor solenoid) receives a refrigerant compression demand signal from the air conditioning amplifier assembly.

Based on this signal, the compressor with pulley assembly (compressor solenoid) changes the amount of compressor output.

DTC No. Detection Item DTC Detection Condition Trouble Area Memory
B1451 Compressor Solenoid Circuit Any of the following conditions is met:
·

Open in compressor solenoid circuit

·

Short in compressor solenoid circuit


·

Compressor with pulley assembly (compressor solenoid)

·

Harness or connector between air conditioning amplifier assembly and compressor with pulley assembly (compressor solenoid)

·

Air conditioning amplifier assembly


-

DTC Detection Conditions
Vehicle Condition
Pattern 1 Pattern 2
Diagnosis Condition Ignition switch ON ○ ○
Malfunction Status Open in compressor solenoid circuit ○ -
Short in compressor solenoid circuit - ○
Detection Time 30 seconds or more 30 seconds or more
Number of Trips 1 trip 1 trip

HINT:

DTC will be output when conditions for either of the patterns in the table above are met.


WIRING DIAGRAM

E357647E03
1.052,0.354 1.5,0.583 0.448,0.229 10 false SOL+ 1.104,1.146 1.552,1.375 0.448,0.229 10 false SOL- 0.167,1.792 0.615,2.021 0.448,0.229 10 false C33 0.156,1.958 2.344,2.375 2.188,0.417 10 false Compressor with Pulley Assembly (Compressor Solenoid) 1.542,0.323 1.771,0.542 0.229,0.219 10 false 2 1.542,1.156 1.771,1.375 0.229,0.219 10 false 1 2.083,0.635 3.125,0.875 1.042,0.24 10 false ECU-IG1 NO. 4 3.865,0.417 5.292,0.719 1.427,0.302 10 false from IG1-NO. 1 Relay 5.365,1.188 5.594,1.406 0.229,0.219 10 false 15 5.656,1.156 6.104,1.385 0.448,0.229 10 false SOL- 6.594,1.198 6.823,1.417 0.229,0.219 10 false IC 5.563,1.781 6.01,2.01 0.448,0.229 10 false F72 5.552,1.979 7.094,2.385 1.542,0.406 10 false Air Conditioning Amplifier Assembly

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.INSPECT COMPRESSOR WITH PULLEY ASSEMBLY (COMPRESSOR SOLENOID)
a.

Remove the compressor with pulley assembly (compressor solenoid).

Click hereVehicle Interior>HEATING / AIR CONDITIONING>COMPRESSOR>REMOVAL


b.

Inspect the compressor with pulley assembly (compressor solenoid)

Click hereVehicle Interior>HEATING / AIR CONDITIONING>COMPRESSOR>INSPECTION


Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (COMPRESSOR WITH PULLEY ASSEMBLY (COMPRESSOR SOLENOID) - POWER SOURCE)

NG

REPLACE COMPRESSOR WITH PULLEY ASSEMBLY (COMPRESSOR SOLENOID)

2.CHECK HARNESS AND CONNECTOR (COMPRESSOR WITH PULLEY ASSEMBLY (COMPRESSOR SOLENOID) - POWER SOURCE)
a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
C33-2 (SOL+) - Body ground Ignition switch ON 11 to 14 V



Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (COMPRESSOR WITH PULLEY ASSEMBLY (COMPRESSOR SOLENOID) - AIR CONDITIONING AMPLIFIER ASSEMBLY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK HARNESS AND CONNECTOR (COMPRESSOR WITH PULLEY ASSEMBLY (COMPRESSOR SOLENOID) - AIR CONDITIONING AMPLIFIER ASSEMBLY)
a.

Disconnect the F72 air conditioning amplifier assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
C33-1 (SOL-) - F72-15 (SOL-) Always Below 1 Ω
C33-1 (SOL-) or F72-15 (SOL-) - Body ground Always 10 kΩ or higher



Result:
Result Proceed to
NG A
OK (When troubleshooting according to the Problem Symptoms Table) B
OK (When troubleshooting according to the DTC) C



A

REPAIR OR REPLACE HARNESS OR CONNECTOR

B

C

4.CHECK FOR DTC
4.CHECK FOR DTC
a.

Clear the DTCs.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM (for Manual Air Conditioning System)>DTC CHECK / CLEAR

Body Electrical > Air Conditioner > Clear DTCs
50002 121

b.

Check for DTCs.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM (for Manual Air Conditioning System)>DTC CHECK / CLEAR

Body Electrical > Air Conditioner > Trouble Codes
50001 121

Result:
Result Proceed to
DTCs are not output A
DTCs are output B



A

B

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY