Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.INSTALL OUTER MIRROR RETRACTOR (for LED Type Turn Signal Light)
w/o Panoramic View Monitor System:
Install a new retractor assembly to a new wire harness as shown in the illustration.
Install the retractor assembly with the screw.
Connect the connector.
Engage the guides.
Install the reinforcement with the 4 screws.
Install the cover base A to the wire harness.
Install the cover base A with 3 new screws.
Check that the wire harness is not caught.
Do not damage the screw coating.
Securely tighten the screws so that they will not come loose.
Install the unit drive assembly with the 3 screws.
Connect the connector.
Engage the guides and claws to install a new cover base B.
Install a new seal to the wire harness.
Engage the guides to install the seal.
Do not make gaps between the cover base and seal.
Engage the guides to install the foam.
| *a | Vinyl Tape |
Install the vinyl tape as shown in the illustration.
Assemble the connector housing.
Pull the retainer and release the lock of connector housing.
| *1 | Retainer | *2 | Terminal |
| *a | Unlock Position | *b | Lock Position |
| *c | Front view of connector | - | - |
While referring to the chart below, insert the terminals of the wire harness into the back of a new connector housing until they lock.
| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
| White | - | Green | Brown - White | - | - | - | Gray - Red |
| 9 | 10 | 11 | 12 | 13 | 14 | 15 | 16 |
| Red | Black | Blue | Black - Red | - | - | - | Pink |
When inserting the terminals of the wire harness, compare the new connector with the connector that was cut off during removal and make sure that the arrangement of the wire colors of the terminals is the same as before.
If the insertion position of the terminals is mistaken, the vehicle side control system may be damaged.
Check that the terminals are securely locked and cannot be removed.
Push the retainer and lock the connector.
8794A
2.INSTALL NO. 2 OUTER MIRROR COVER (for Bulb Type Turn Signal Light)
w/ Illumination:
|
Install in this Direction |
Engage the claws to install the No. 2 outer mirror cover as shown in the illustration.
86790F
3.INSTALL SIDE TELEVISIN CAMERA ASSEMBLY (w/ Panoramic View Monitor System)
81890D
4.INSTALL OUTER MIRROR LIGHT ASSEMBLY (for LED Type Turn Signal Light)
w/o Panoramic View Monitor System:
Click hereVehicle Exterior>LIGHTING (EXT)>DOOR MIRROR FOOT LIGHT>INSTALLATION
81890D
5.INSTALL OUTER MIRROR LIGHT ASSEMBLY (for Bulb Type Turn Signal Light)
w/ Illumination:
Click hereVehicle Exterior>LIGHTING (EXT)>DOOR MIRROR FOOT LIGHT>INSTALLATION
6.INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY (for LED Type Turn Signal Light)
81730B
7.INSTALL SIDE TURN SIGNAL LIGHT BULB (for Bulb Type Turn Signal Light)
87945
8.INSTALL OUTER MIRROR COVER (for LED Type Turn Signal Light)
87945
9.INSTALL OUTER MIRROR COVER (for Bulb Type Turn Signal Light)
87961
10.INSTALL OUTER MIRROR (for LED Type Turn Signal Light)
87961
11.INSTALL OUTER MIRROR (for Bulb Type Turn Signal Light)