The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel pressure regulator assembly removal/installation are shown below.
*1: When performing learning using the GTS.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM>CALIBRATION
Never perform work on fuel system components near any possible ignition sources.
Vaporized fuel could ignite, resulting in a serious accident.
Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.
Sparks could cause vaporized fuel to ignite, resulting in a serious accident.
77020A
1.REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
83320
2.REMOVE FUEL SENDER GAUGE ASSEMBLY
23221
3.REMOVE FUEL PUMP
23280J
4.REMOVE FUEL PRESSURE REGULATOR ASSEMBLY
Using a screwdriver with its tip wrapped with protective tape, remove the fuel pressure regulator assembly from the fuel filter.
Pull out the fuel pressure regulator assembly carefully because the O-rings are firmly installed between the fuel pressure regulator assembly and fuel filter.
Do not damage the fuel filter.
| *1 | O-ring |
Remove the 2 O-rings from the fuel pressure regulator assembly.