Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
86212C
1.INSTALL NO. 2 RADIO RECEIVER BRACKET
Install the No. 2 radio receiver bracket with the 2 screws to the radio and display receiver assembly.
86211J
2.INSTALL NO. 1 RADIO RECEIVER BRACKET
Install the No. 1 radio receiver bracket with the 2 screws to the radio and display receiver assembly.
55405B
3.INSTALL INSTRUMENT CLUSTER FINISH CENTER PANEL SUB-ASSEMBLY
Engage the claws to install the instrument cluster finish center panel sub-assembly.
86140A
4.INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET
Connect each connector.
|
Install in this Direction |
Engage the clips and claws to install the radio and display receiver assembly with bracket as shown in the illustration.
Install the 4 screws.
55670A
5.INSTALL INSTRUMENT PANEL CENTER REGISTER ASSEMBLY
55406B
6.INSTALL INSTRUMENT CLUSTER FINISH LOWER CENTER PANEL SUB-ASSEMBLY
55470
7.INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY
8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
for 8NR-FTS:
for 3ZR-FAE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION