Home › Drivetrain › K313F (MULTIDRIVE / CVT) › PARK / NEUTRAL POSITION SWITCH › 2019.09–2020.08
RM32H0E _52 Drivetrain _059618 K313F MULTIDRIVE / CVT _0292482 PARK / NEUTRAL POSITION SWITCH A

K313F MULTIDRIVE / CVT  PARK / NEUTRAL POSITION SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the park/neutral position switch removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative battery terminal Perform steering sensor zero point calibration
·

Lane departure alert system (w/ Steering Control)

·

Toyota parking assist-sensor system*1

·

Parking support brake system*1

·

Simple intelligent parking assist system*1

·

Pre-collision system


(Click here)
Memorize steering angle neutral point Panoramic view monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)

PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Click hereGeneral>MAINTENANCE>8NR-FTS BATTERY>REMOVAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.SECURE VEHICLE

a.

Fully apply the parking brake and chock a wheel.

CAUTION:
·
C332327

Make sure to apply the parking brake and chock a wheel before performing this procedure.

·

If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.




Hide 28800 4.REMOVE BATTERY

Hide 53141F 5.REMOVE RADIATOR COVER

Hide 17751 6.REMOVE NO. 1 AIR CLEANER INLET

Hide 17705 7.REMOVE AIR CLEANER CAP SUB-ASSEMBLY

Hide 17701 8.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

Hide 33820B 11.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

a.

Move the shift lever to N.


b.
C327175

Remove the nut and disconnect the transmission control cable assembly from the control shaft lever.


c.

Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.


Hide 84540 12.REMOVE PARK/NEUTRAL POSITION SWITCH

a.
C278997

Disconnect the park/neutral position switch connector.


b.

Remove the nut, washer and control shaft lever from the continuously variable transaxle assembly.


c.
C151658

Using a screwdriver, bend back the tabs of the lock plate.


d.

Remove the lock nut and lock plate from the park/neutral position switch.


e.
C151659

Remove the 2 bolts and park/neutral position switch from the continuously variable transaxle assembly.