Home › Power Source / Network › 8NR-FTS (BATTERY / CHARGING) › GENERATOR (for DENSO Made) › 2019.09–2020.08
RM32H0E _57 Power Source / Network _060209 8NR-FTS BATTERY / CHARGING _0295252 GENERATOR(for DENSO Made) A

8NR-FTS BATTERY / CHARGING  GENERATOR(for DENSO Made)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures(adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the generator assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link

*1: When performing learning using the GTS

Click here(Click here)

Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Toyota parking assist-sensor system*1
Parking support brake system*1
Parking support brake system*1
Pre-collision syatem
Memorize steering angle neutral point Panoramic view monitor system (Click here)
Initialize back door lock Power door lock control system (Click here)

PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Click hereGeneral>MAINTENANCE>8NR-FTS BATTERY>REMOVAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.REMOVE FAN AND GENERATOR V BELT

Hide 27020 5.REMOVE GENERATOR ASSEMBLY

a.
A394426

Remove the terminal cap.


b.

Remove the nut to disconnect the engine wire from terminal B.


c.

Disconnect the generator assembly connector.


d.

Disengage the wire harness clamp.


e.
A394427

Remove the bolt and 2 nuts from the generator assembly.


f.

Remove the generator assembly.


g.
A351882

Remove the bolt and wire harness clamp bracket from the generator assembly.