Home › Drivetrain › EC6A (MANUAL TRANSMISSION / TRANSAXLE) › MANUAL TRANSAXLE SYSTEM › from 2019.09
RM32H0E _52 Drivetrain _059609 EC6A MANUAL TRANSMISSION / TRANSAXLE _0292533 MANUAL TRANSAXLE SYSTEM T

EC6A MANUAL TRANSMISSION / TRANSAXLE  MANUAL TRANSAXLE SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



Manual Transmission
Symptom Suspected Area Link
Abnormal noise Oil level (Low) Click here
Oil (Wrong) -
Clutch release with bearing cylinder assembly (Worn or damaged) Click here
Clutch disc*1 (Worn or damaged) Click here
Synchronizer ring (Input shaft) (Worn or damaged) Click here
Synchronizer ring (Output shaft) (Worn or damaged) Click here
Gear (Input shaft) (Worn or damaged) Click here
Gear (Output shaft) (Worn or damaged) Click here
Bearing (Input shaft) (Worn or damaged) Click here
Bearing (Output shaft) (Worn or damaged) Click here
Bearing (Differential case) (Worn or damaged) Click here
Oil leak Oil level (High) Click here
Gasket (Damaged) Click here
Oil seal (Worn or damaged) Click here
Clutch release with bearing cylinder assembly (Worn or damaged) Click here
Hard shifting or impossible to shift Oil (Wrong) -
Clutch (Dragging) Click here
Shift and select lever assembly (Worn or damaged) Click here
Transmission control cable assembly (Faulty) Click here
Shift fork (Input shaft) (Worn) Click here
Shift fork (Output shaft) (Worn) Click here
Synchronizer ring (Input shaft) (Worn or damaged) Click here
Synchronizer ring (Output shaft) (Worn or damaged) Click here
Shift key spring (Input shaft) (Worn or damaged) Click here
Shift key spring (Output shaft) (Worn or damaged) Click here
Gear (Input shaft) (Worn or damaged) Click here
Gear (Output shaft) (Worn or damaged) Click here
Hub sleeve (Input shaft) (Worn or damaged) Click here
Hub sleeve (Output shaft) (Worn or damaged) Click here
Jumps out of gear or shift lever moves excessively Shift fork (Input shaft) (Worn) Click here
Shift fork (Output shaft) (Worn) Click here
Hub sleeve (Input shaft) (Worn or damaged) Click here
Hub sleeve (Output shaft) (Worn or damaged) Click here
Gear (Input shaft) (Worn or damaged) Click here
Gear (Output shaft) (Worn or damaged) Click here
Bearing (Input shaft) (Worn or damaged) Click here
Bearing (Output shaft) (Worn or damaged) Click here

*1: If the clutch torsional damper springs are worn, they can produce a load-related noise similar to a bad bearing or gear rattle.

iMT System
Symptom Suspected Area Link
iMT indicator light does not illuminate CAN communication system Click here
Combination meter assembly Click here
Pattern select switch iMT mode circuit Click here
ECM Click here
Blipping does not operate and engine speed does not increase sufficiently or increases too much Clutch pedal stroke sensor assembly (for LHD) Click here
Clutch pedal stroke sensor assembly (for RHD) Click here
Transmission revolution sensor Click here
Installation condition of clutch components Click here
Installation condition of manual transmission assembly components Click here
Click here
ECM Click here