Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.INSTALL HEADLIGHT ASSEMBLY
|
Install in this Direction |
Temporarily install the headlight assembly as shown in the illustration.
Install the headlight assembly with the bolt and 3 screws.
| *a | Connector Lock Lever |
|
Install in this Direction |
Connect the connector A.
Connect the connector B and raise the connector lock lever to engage the claw and lock the connector as shown in the illustration.
Remove the protective tape.
85319A
2.INSTALL INLET HOSE (for RH Side)
Install the inlet hose with the clip.
3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
for 8NR-FTS:
for 3ZR-FAE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
4.INSTALL FRONT BUMPER ASSEMBLY
5.PERFORM INITIALIZATION
6.ADJUST HEADLIGHT AIMING