Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
42450B
1.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY (for 2WD)
Install the rear axle hub and bearing assembly and rear disc brake dust cover sub-assembly to the rear axle carrier sub-assembly with the 4 bolts.
42450B
2.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY (for AWD)
| *a | Matchmark |
Align the matchmarks on the rear drive shaft assembly and rear axle hub and bearing assembly.
Be careful not to damage the thread portion of the rear drive shaft assembly.
Install the rear axle hub sub-assembly and rear disc brake dust cover to the rear axle carrier with the 4 bolts.
Be careful not to damage the drive shaft boot.
42431
3.INSTALL REAR DISC
for TMC Made:
Click hereBrake>BRAKE (REAR)>REAR BRAKE (for TMC Made)>INSTALLATION
for TMMT Made:
Click hereBrake>BRAKE (REAR)>REAR BRAKE (for TMMT Made)>INSTALLATION
4.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY
42312B
5.TEMPORARILY TIGHTEN REAR AXLE SHAFT NUT
Clean the threaded parts on the rear drive shaft assembly and a new rear axle shaft nut using non-residue solvent.
Be sure to perform this work even when using a new rear drive shaft assembly.
Keep the threaded parts free of oil and foreign matter.
Using a 30 mm socket wrench, install the rear axle shaft nut.
Stake the rear axle shaft nut after inspecting for looseness and runout in the following steps.
Depress the brake pedal to prevent the drive shaft from rotating.
6.SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY
42431
7.REMOVE REAR DISC
for TMC Made:
Click hereBrake>BRAKE (REAR)>REAR BRAKE (for TMC Made)>REMOVAL
for TMMT Made:
Click hereBrake>BRAKE (REAR)>REAR BRAKE (for TMMT Made)>REMOVAL
8.INSPECT REAR AXLE HUB BEARING LOOSENESS
9.INSPECT REAR AXLE HUB RUNOUT
42431
10.INSTALL REAR DISC
for TMC Made:
Click hereBrake>BRAKE (REAR)>REAR BRAKE (for TMC Made)>INSTALLATION
for TMMT Made:
Click hereBrake>BRAKE (REAR)>REAR BRAKE (for TMMT Made)>INSTALLATION
11.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY
12.STAKE REAR AXLE SHAFT NUT
Using a chisel and hammer, stake the rear axle shaft nut.
13.CONNECT SKID CONTROL SENSOR WIRE (for 2WD)
Connect the skid control sensor connector to the rear axle hub and bearing assembly.
14.CONNECT SKID CONTROL SENSOR WIRE (for AWD)
Connect the skid control sensor connector to the rear axle hub and bearing assembly.
15.INSTALL REAR WHEEL
16.CHECK FOR SPEED SENSOR SIGNAL