Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Wear protective gloves. Sharp areas on the parts may injure your hands.
If the front seat airbag assembly has been deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback pad and separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage.
Power seat is available only on the driver side.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
87501B
1.INSTALL SEAT HEATER CONTROL SUB-ASSEMBLY
Engage the claw to install the seat heater control sub-assembly.
7181B
2.INSTALL FRONT SEAT CUSHION WIRE HARNESS HOLDER
71052A
3.INSTALL FRONT SEAT CUSHION SPRING SUB-ASSEMBLY
82192
4.INSTALL FRONT SEAT WIRE
82192
5.CONNECT FRONT SEAT WIRE
Engage the claw to connect the front seat wire.
82192B
6.INSTALL NO. 2 FRONT SEAT WIRE (w/ Seat Position Airbag Sensor)
73240
7.INSTALL FRONT SEAT INNER BELT ASSEMBLY
8.INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD