Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM › 2019.09–2020.08
RM32H0E _56 Audio / Visual / Telematics _060571 PARK ASSIST / MONITORING _0407351 TOYOTA PARKING ASSIST-SENSOR SYSTEM T

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.

·

When an open circuit or frozen indication is displayed by the self-check function, check for DTCs and troubleshoot according to each inspection procedure.



General
Symptom Suspected Area Link
System does not operate at all Proceed to "Clearance Warning ECU Power Source Circuit" Click here
CAN communication system Click here
Meter / gauge system Click here
Clearance warning ECU assembly Click here
System cannot be turned off CAN communication system Click here
Meter / gauge system Click here
Clearance warning ECU assembly Click here

Sonar Function
Symptom Suspected Area Link
Frozen indication is displayed in self-check function Proceed to "Sensor Frozen Indication (Dirty or Frozen)" Click here
Combination meter assembly (shift selection) operates normally, but detection operates when shift lever is in P, or detection does not operate when shift lever is in any position other than P (front sonar) CAN communication system Click here
Clearance warning ECU assembly Click here
Combination meter assembly (shift selection) operates normally, but detection operates when shift lever is not in R, or does not operate with shift lever in R (rear sonar) CAN communication system Click here
Clearance warning ECU assembly Click here
Combination meter assembly (speedometer) operates normally, but detection does not operate when vehicle speed meets operation condition, or detection operates when vehicle speed does not meet operation condition (front sonar) CAN communication system Click here
Clearance warning ECU assembly Click here

Buzzer Function
Symptom Suspected Area Link
Sonar detection operation is normal but buzzer does not sound Check that the temporary mute function is not operating -
Proceed to "No. 1 Clearance Warning Buzzer Circuit" Click here
Proceed to "No. 2 Clearance Warning Buzzer Circuit" Click here
Clearance warning ECU assembly Click here

Display Function
Symptom Suspected Area Link
Detection operation is normal but clearance sonar indicator does not illuminate CAN communication system Click here
Combination Meter Assembly Click here
Clearance warning ECU assembly Click here
Detection operation is normal but sonar displays do not appear on multi-information display CAN communication system Click here
Combination Meter Assembly Click here
Clearance warning ECU assembly Click here

RCTA Function (w/ Blind Spot Monitor System)
Symptom Suspected Area Link
Function does not operate at all
(Blind spot monitor function operates normally)
Data List / Active Test (Reverse) Click here
Blind spot monitor sensor LH (B) Click here
"Rear Cross Traffic Alert Malfunction Visit Your Dealer" or "RCTA Unavailable" is displayed on the multi-information display Check abnormality history Click here
Blind spot monitor sensor LH (B) Click here
Blind spot monitor sensor RH (A) Click here
Combination meter assembly Click here
While RCTA function is active, outer rear view mirror indicator flashes but RCTA buzzer does not sound Proceed to "Buzzer does not Sound" Click here