Home › Engine / Hybrid System › 3ZR-FAE (ENGINE CONTROL) › ENGINE COOLANT TEMPERATURE SENSOR › 2019.09–2020.08
RM32H0E _51 Engine / Hybrid System _059607 3ZR-FAE ENGINE CONTROL _0293878 ENGINE COOLANT TEMPERATURE SENSOR A

3ZR-FAE ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the engine coolant temperature sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link

*1: When performing learning using the GTS.

Click here(Click here)

Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Simple intelligent parking assist system*1 (Click here)
Toyota parking assist-sensor system*1
Initialize back door lock Power door lock control system (Click here)
Replacement of engine coolant temperature sensor Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DRAIN ENGINE COOLANT

Hide 28800 3.REMOVE BATTERY

Hide 17705 5.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

Hide 16571C 6.DISCONNECT NO. 1 RADIATOR HOSE

Hide 89422 7.REMOVE ENGINE COOLANT TEMPERATURE SENSOR

a.
A393506

Disconnect the engine coolant temperature sensor connector.


b.
A393507E01
1.125,1.469 1.521,1.292 true 0.781,1.365 1.125,1.552 0.344,0.188 10 true SST

Using SST, remove the engine coolant temperature sensor from the cylinder head sub-assembly.

SST
09817-33191  

NOTICE:

If the engine coolant temperature sensor has been struck or dropped, replace it.



c.

Remove the gasket from the engine coolant temperature sensor.