The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the air fuel ratio sensor removal/installation are shown below.
When the engine is hot, do not touch high-temperature areas such as the engine or exhaust manifold.
Touching high-temperature areas such as the engine and exhaust manifold could result in burns.
1.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
55737B
2.REMOVE NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL
55735A
3.REMOVE WATER GUARD PLATE LH (for TMC Made RHD)
55736D
4.REMOVE COWL BODY MOUNTING REINFORCEMENT LH
55735C
5.REMOVE COWL BODY MOUNTING REINFORCEMENT RH
55701J
6.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)
55701J
7.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)
51441
8.REMOVE NO.1 ENGINE UNDER COVER
55225
9.REMOVE DASH PANEL HEAT INSULATOR
for LHD:
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER (for LHD)>REMOVAL
for RHD:
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE BOOSTER (for RHD)>REMOVAL
89467B
10.REMOVE AIR FUEL RATIO SENSOR
Disengage the wire harness clamp.
Disconnect the air fuel ratio sensor connector.
Using SST, remove the air fuel ratio sensor from the exhaust manifold converter sub-assembly.
If the air fuel ratio sensor has been struck or dropped, replace it.