Home › Engine / Hybrid System › 8NR-FTS (COOLING) › WATER PUMP › 2019.09–2020.08
RM32H0E _51 Engine / Hybrid System _060195 8NR-FTS COOLING _0295082 WATER PUMP A

8NR-FTS COOLING  WATER PUMP  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the engine water pump assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link

*1: When performing learning using the GTS

Click here(Click here)

Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Toyota parking assist-sensor system*1
Pre-collision syatem
Parking support brake system*1
Initialize back door lock Power door lock control system (Click here)
Memorize steering angle neutral point Panoramic view monitor system (Click here)

PROCEDURE

Hide 51441 1.REMOVE NO. 1 ENGINE UNDER COVER

Hide 16620 4.REMOVE V-RIBBED BELT TENSIONER ASSEMBLY

Hide 5.REMOVE ENGINE WATER PUMP ASSEMBLY

a.
A350042

Remove the 6 bolts and engine water pump assembly from the timing chain cover assembly.


b.
A350043

Remove the water pump gasket from the engine water pump assembly.