Home › Vehicle Interior › HEATING / AIR CONDITIONING › BLOWER UNIT (for VALEO Made) › from 2020.08
RM32H0E _58 Vehicle Interior _059841 HEATING / AIR CONDITIONING _0293720 BLOWER UNIT(for VALEO Made) A

HEATING / AIR CONDITIONING  BLOWER UNIT(for VALEO Made)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the blower assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative (-) battery terminal Memorize steering angle neutral point Panoramic view monitor system (Click here)
AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)
·

No. 1 Blower Damper Servo Sub-assembly (Fresh/Recirculation)


AIR CONDITIONING SYSTEM (for Manual Air Conditioning System)
·

No. 1 Blower Damper Servo Sub-assembly (Fresh/Recirculation)


Initialize servo motor (Air conditioning system) DTCs are stored for Automatic Air Conditioning System:(Click here)
for Manual Air Conditioning System:(Click here)

HINT:
·

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: When performing learning using the GTS

Click here(Click here)

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Simple intelligent parking assist system*1
Parking support brake system*1


-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -


·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

Make sure to perform initialization after replacing the No. 1 blower damper servo sub-assembly. If initialization is not performed, the air conditioner unit assembly will not perform properly as the air conditioning amplifier assembly will not be able to recognize the position of the No. 1 blower damper servo sub-assembly.


Hide 82143 5.REMOVE NO. 3 INSTRUMENT PANEL WIRE (w/ PTC Heater)

Hide 87130D 6.REMOVE BLOWER ASSEMBLY

a.

for LHD:

i.
I112385

Disconnect the connector.


ii.

Disengage the guide.


iii.
I112386

Remove the 2 screws.


iv.

Disengage the guides to remove the blower assembly from the air conditioning radiator assembly.



b.

for RHD:

i.
I112387

Disconnect the connector.


ii.

Disengage the guide.


iii.
I112388

Remove the 2 screws.


iv.

Disengage the guides to remove the blower assembly from the air conditioning radiator assembly.