Home › Engine / Hybrid System › 8NR-FTS (STARTING) › STARTER (for Denso Made without Stop and Start System) › from 2020.08
RM32H0E _51 Engine / Hybrid System _060199 8NR-FTS STARTING _0295162 STARTER(for Denso Made without Stop and Start System) A

8NR-FTS STARTING  STARTER(for Denso Made without Stop and Start System)  INSTALLATION  


PROCEDURE

Hide 28100 1.INSTALL STARTER ASSEMBLY

a.

Install the starter assembly to the cylinder block sub-assembly with the 2 bolts.

Torque:
w/ Washer : 37 N*m (377 kgf*cm, 27 ft.*lbf)
w/o Washer : 46 N*m (469 kgf*cm, 34 ft.*lbf)


b.

Connect the wire harness to the terminal 30 with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


c.

Close the terminal cap.


d.

Connect the starter assembly connector.


Hide 2.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 51441 3.INSTALL NO. 1 ENGINE UNDER COVER

Hide 4. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART