Home › Power Source / Network › 8NR-FTS (BATTERY / CHARGING) › GENERATOR (for DENSO Made) › from 2020.08
RM32H0E _57 Power Source / Network _060209 8NR-FTS BATTERY / CHARGING _0295252 GENERATOR(for DENSO Made) A

8NR-FTS BATTERY / CHARGING  GENERATOR(for DENSO Made)  INSTALLATION  


PROCEDURE

Hide 27020 1.INSTALL GENERATOR ASSEMBLY

a.

Install the wire harness clamp bracket to the generator assembly with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


b.

Install the generator assembly with the bolt and 2 nuts.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)


c.

Engage the wire harness clamp.


d.

Connect the generator assembly connector.


e.

Connect the engine wire to the terminal B with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


f.

Install the terminal cap.


Hide 3.INSTALL FAN AND GENERATOR V BELT

Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 5. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART