The millimeter wave radar sensor assembly receives vehicle information (Conv/HV/EV) or vehicle information (transmission type) from the ECM via the CAN communication line.
If the millimeter wave radar sensor assembly cannot confirm the vehicle information (Conv/HV/EV) or vehicle information (transmission type) sent from the ECM, the millimeter wave radar sensor assembly stores DTC U030051.
If the vehicle information (Conv/HV/EV) or vehicle information (transmission type) stored in the millimeter wave radar sensor assembly does not match the vehicle information sent from the ECM, the millimeter wave radar sensor assembly stores DTC U030057.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U030051 | Internal Control Module Software Incompatibility Not Programmed | When the ignition switch is ON for 3 seconds or more, the millimeter wave radar sensor assembly cannot confirm the vehicle information (Conv/HV/EV) or vehicle information (transmission type) sent from the ECM for approximately 3 seconds or more. | ·
SFI system ·
Millimeter wave radar sensor assembly ·
ECM |
| U030057 | Internal Control Module Software Incompatibility Invalid / Incompatible Software Component | When the ignition switch is ON for 3 seconds or more, the vehicle information (Conv/HV/EV) or vehicle information (transmission type) stored in the millimeter wave radar sensor assembly does not match the vehicle information sent from the ECM for approximately 1 second or more. | ·
SFI system ·
Millimeter wave radar sensor assembly ·
ECM |
When replacing the millimeter wave radar sensor assembly, always replace it with a new one. If a millimeter wave radar sensor assembly which was installed to another vehicle is used, the information stored in the millimeter wave radar sensor assembly will not match the information from the vehicle and a DTC may be stored.
When the millimeter wave radar sensor assembly has been replaced with a new one, it is necessary to perform millimeter wave radar sensor assembly beam axis alignment and to clear the vehicle control history. Before performing the Driving Adjustment, make sure to read Before Starting Driving Adjustment.
Beam axis alignment of the millimeter wave radar sensor assembly can be performed using either Triangle Target, Flat Surface Target or Driving Adjustment.
Triangle Target: Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>TARGET ADJUSTMENT(TRIANGLE TARGET)
Flat Surface Target: Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>TARGET ADJUSTMENT(FLAT SURFACE TARGET)
Driving Adjustment: Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>DRIVING ADJUSTMENT
Before replacing the ECM, refer to Service Bulletin.
Using the GTS, check for SFI system DTCs.
If DTC U030051 or U030057 is output by the pre-collision system, it is possible that SFI system DTCs have been stored, so perform troubleshooting for the SFI system.
| Result | Proceed to |
|---|---|
| SFI system DTCs are not output | A |
| SFI system DTCs are output | B |
A
B
Using the GTS, perform the Health Check.
Check for DTCs.
ECUs other than the millimeter wave radar sensor assembly do not output specification information mismatch DTCs related to the ECM.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Using the GTS, read the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Vehicle Information (Conv/HV/EV) | Vehicle information (Conv/HV/EV) | Unknown / Conv / HV/EV | Unknown: Vehicle information not confirmed
Conv: Conventional HV/EV: Hybrid vehicle |
- |
| Tester Display |
|---|
| Vehicle Information (Conv/HV/EV) |
When the specification stored by the millimeter wave radar sensor assembly and the vehicle specification do not match, there is a malfunction in the specification information stored by the millimeter wave radar sensor assembly. Therefore, replace the millimeter wave radar sensor assembly.
When the specification stored by the millimeter wave radar sensor assembly and the vehicle specification match, an ECM with different specifications may be installed. Therefore, replace the ECM.
| Result | Proceed to |
|---|---|
| Vehicle information stored in millimeter wave radar sensor assembly and actual vehicle specifications do not match | A |
| "Unknown" is displayed | |
| Vehicle information stored in millimeter wave radar sensor assembly and actual vehicle specifications match | B |
A
B
Using the GTS, read the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Vehicle Information (Transmission Type) | Vehicle Information (Transmission Type) | MT / AT / CVT / MMT / SMT / HV/EV - AT / Unknown | Displays the type of transmission | - |
| Tester Display |
|---|
| Vehicle Information (Transmission Type) |
When the specification stored by the millimeter wave radar sensor assembly and the vehicle specification do not match, there is a malfunction in the specification information stored by the millimeter wave radar sensor assembly. Therefore, replace the millimeter wave radar sensor assembly.
When the specification stored by the millimeter wave radar sensor assembly and the vehicle specification match, an ECM with different specifications may be installed. Therefore, replace the ECM.
| Result | Proceed to |
|---|---|
| Vehicle information stored in millimeter wave radar sensor assembly and actual vehicle specifications do not match | A |
| "Unknown" is displayed | |
| Vehicle information stored in millimeter wave radar sensor assembly and actual vehicle specifications match | B |
A
B