Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
83100
1.INSTALL COMBINATION METER ASSEMBLY
Connect the 2 connectors to install the combination meter assembly.
Engage the guides and clips.
Install the 2 screws.
55414C
2.INSTALL STARTER SWITCH BEZEL (for RHD with Entry and Start System)
55012A
3.INSTALL NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY
55410C
4.INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
55470
5.INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY
55404D
6.INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag)
for 8NR-FTS:
for 3ZR-FAE:
8. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART