28100
1.INSTALL STARTER ASSEMBLY
Install the starter assembly to the cylinder block sub-assembly with the 2 bolts.
Connect the wire harness to the terminal 30 with the nut.
Close the terminal cap.
Connect the starter assembly connector.
2.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
51441
3.INSTALL NO. 1 ENGINE UNDER COVER
4. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART