The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the cylinder head gasket removal/installation are shown below.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is operated normally
11103
1.REMOVE CAMSHAFT HOUSING SUB-ASSEMBLY
16268
2.REMOVE NO. 1 WATER BY-PASS PIPE
Remove the 2 bolts and No. 1 water by-pass pipe.
13716
3.REMOVE VALVE STEM CAP
11101
4.REMOVE CYLINDER HEAD SUB-ASSEMBLY
Using a 10 mm bi-hexagon wrench, uniformly loosen and remove the 10 cylinder head set bolts and 10 plate washers in several steps in the order shown in the illustration.
Removing the cylinder head set bolts in the wrong order may cause warpage or cracking of the cylinder head sub-assembly.
Do not drop the plate washers into the cylinder head sub-assembly.
Using a screwdriver, remove the cylinder head sub-assembly by prying between the cylinder head sub-assembly and cylinder block sub-assembly.
Be careful not to damage the contact surfaces of the cylinder head sub-assembly and cylinder block sub-assembly.
Tape the screwdriver tip before use.
11115
5.REMOVE CYLINDER HEAD GASKET
Remove the cylinder head gasket from the cylinder block sub-assembly.
6.INSPECT CYLINDER HEAD FOR FLATNESS
11101A
7.INSPECT CYLINDER HEAD SET BOLT