Home › Drivetrain › K114 (MULTIDRIVE / CVT) › REVOLUTION SENSOR › from 2020.08
RM32H0E _52 Drivetrain _059616 K114 MULTIDRIVE / CVT _0292455 REVOLUTION SENSOR A

K114 MULTIDRIVE / CVT  REVOLUTION SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transmission revolution sensor removal/installation are shown below.

HINT:

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: When performing learning using the GTS

Simple intelligent parking assist system*1 Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING SUPPORT BRAKE SYSTEM>CALIBRATION

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 28800 3.REMOVE BATTERY

Hide 53141F 5.REMOVE RADIATOR COVER

Hide 17751 6.REMOVE NO. 1 AIR CLEANER INLET

Hide 17705 7.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

Hide 8.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

Hide 74404A 10.REMOVE BATTERY CLAMP SUB-ASSEMBLY

Hide 89413P 11.REMOVE TRANSMISSION REVOLUTION SENSOR (NIN)

C296015

a.

Disconnect the connector.


b.

Remove the bolt and transmission revolution sensor (NIN) from the continuously variable transaxle assembly.


c.

Remove the O-ring from the transmission revolution sensor (NIN).


Hide 89413M 12.REMOVE TRANSMISSION REVOLUTION SENSOR (NOUT)

C296016

a.

Disconnect the connector.


b.

Remove the bolt and transmission revolution sensor (NOUT) from the continuously variable transaxle assembly.


c.

Remove the O-ring from the transmission revolution sensor (NOUT).


Hide 89413N 13.REMOVE TRANSMISSION REVOLUTION SENSOR (NT)

C296014

a.

Disconnect the connector.


b.

Remove the bolt and transmission revolution sensor (NT) from the continuously variable transaxle assembly.


c.

Remove the O-ring from the transmission revolution sensor (NT).