DIAGNOSIS SYSTEM
Troubleshooting · Vehicles built Oct 2006 – May 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
| BUS CHECK |
- HINT:
- Only CAN communication system DTCs for each ECU can be displayed on the intelligent tester.
Select "Bus Check" from the "System Select" screen on the intelligent tester.

Select "Communication Malfunction DTC" from the "Bus Check" screen, and then select "Enter".

Select the system of the DTC to be checked and select "Details".

CAN communication system DTC(s) is/are displayed.

| CHECK FOR INSTALLED SYSTEMS (ECUS AND SENSORS) THAT ADOPT CAN COMMUNICATION |
Systems (ECUs, sensors) that adopt CAN communication vary depending on the vehicle's optional settings. Check which systems (ECUs, sensors) are installed on the vehicle.
ECU/Sensor name
Check method
Skid control ECU
Installed on all vehicles
Steering angle sensor
Installed on all vehicles
Yaw rate sensor
Installed on all vehicles
ECM
Installed on all vehicles
Center airbag sensor
Installed on all vehicles
Air conditioning amplifier
Installed on all vehicles
Combination meter
Installed on all vehicles
Main body ECU
Installed on all vehicles
Certification ECU
Installed on all vehicles
Gateway ECU
with adaptive front-lighting system (AFS)
Outer mirror control ECU
with seat position memory
Clearance warning ECU
Installed on all vehicles
Seat position control ECU (Front RH side)
with seat position memory
AFS ECU
with adaptive front-lighting system (AFS)
| DTC TABLE BY ECU |
- HINT:
- In the CAN communication system, CAN communication system DTCs can be displayed by the ECU using the intelligent tester.
- If CAN communication system DTCs are output, trouble cannot be determined only by the DTCs. Perform troubleshooting according to "HOW TO PROCEED WITH TROUBLESHOOTING". (Click here)
- In the CAN communication system, CAN communication system DTCs can be displayed by the ECU using the intelligent tester.
ECM
- HINT:
- DTC communication uses the CAN communication system.
DTC No.
Detection Item
U0101 (*1)
Lost Communication with Transfer Case Control Module
- *: If only DTC U0101 is output, refer to the SFI system (Click here)
ECT
DTC No.
Detection Item
U0100*
High speed CAN Communication Bus
- HINT:
- DTC communication is via the CAN communication system.
- *: The ECM is malfunctioning if only U0100 is output. Refer to Automatic Transaxle system (Click here).
- DTC communication is via the CAN communication system.
SKID CONTROL ECU
- HINT:
- DTC communication uses the CAN communication system.
DTC No.
Detection Item
U0073
Control Module Communication Bus Off
U0100
Lost Communication with ECM/PCM "A"
U0123
Lost Communication with Yaw Rate Sensor Module
U0124
Lost Communication with Lateral Acceleration Sensor Module
U0126
Lost Communication with Steering Angle Sensor Module
COMBINATION METER
- HINT:
- DTC communication uses the CAN communication system.
DTC No.
Detection Item
U0100
Lost Communication with ECM/PCM "A"
U0129
Lost Communication with Brake System Control Module
AIR CONDITIONER AMPLIFIER
DTC No.
Detection Item
B1499
Multiplex Communication Circuit
- HINT:
- DTC communication is via the CAN communication system.
GATEWAY ECU (with adaptive front-lighting system)
- HINT:
- DTC communication uses the CAN communication system.
DTC No.
Detection Item
U0182
Lost Communication with AFS ECU
U1002
Lost Communication with Gateway Module
AFS ECU (with adaptive front-lighting system)
- HINT:
- DTC communication uses the CAN communication system.
DTC No.
Detection Item
B2427
CAN Communication Malfunction
CENTER AIRBAG SENSOR
- HINT:
- The center airbag sensor is connected to the CAN communication system, but CAN communication DTCs are not output.
STEERING ANGLE SENSOR
- HINT:
- The steering angle sensor is connected to the CAN communication system, but CAN communication DTCs are not output.
YAW RATE SENSOR
- HINT:
- The yaw rate sensor is connected to the CAN communication system, but CAN communication DTCs are not output.
OUTER MIRROR CONTROL ECU
- HINT:
- The outer mirror control ECU sensor is connected to the CAN communication system, but CAN communication DTCs are not output.
CERTIFICATION ECU
- HINT:
- The certification ECU is connected to the CAN communication system, but CAN communication DTCs are not output.
CLEARANCE WARNING ECU
- HINT:
- The clearance warning ECU is connected to the CAN communication system, but CAN communication DTCs are not output.
SEAT POSITION CONTROL ECU (FRONT RH SIDE)
- HINT:
- The seat position control ECU (front RH side) is connected to the CAN communication system, but CAN communication DTCs are not output.
| DTC COMBINATION TABLE |
CAN No. 1 Bus
*: with Adaptive front-lighting systemDTC
Trouble Mode
Output from
Output DTC
ECM Communication Stop Mode
Skid Control ECU Communication Stop Mode
Steering Angle Sensor Communication Stop Mode
Yaw Rate Sensor Communication Stop Mode
Combination Meter ECU Communication Stop Mode
Skid Control ECU
U0073
X
X
X
X
X
U0100
□ During driving
X
X
X
X
U0123
X
X
X
○
X
U0124
X
X
X
○
X
U0126
X
X
○
X
X
ECM
U0100
X
X
X
X
X
Combination Meter ECU
U0100
○
X
X
X
X
U0129
X
○
X
X
X
AFS ECU *
B2427
○
○
○
X
X
- HINT:
- ○: Set
- X: Not set or may be set according to the malfunctioning part when one side of the CAN bus wire opens
- □: Set under the condition shown in the table above
- ○: Set
*: with Adaptive front-lighting systemDTC
Trouble Mode
Output from
Output DTC
Air Conditioning Amplifier Communication Stop Mode
Center Airbag Sensor Communication Stop Mode
Gateway ECU Communication Stop Mode
Main Body ECU Communication Stop Mode
Skid Control ECU
U0073
X
X
X
X
U0100
X
X
X
X
U0123
X
X
X
X
U0124
X
X
X
X
U0126
X
X
X
X
ECM
U0100
X
X
X
X
Combination Meter ECU
U0100
X
X
X
X
U0129
X
X
X
X
AFS ECU *
B2427
X
X
X
○
- HINT:
- ○: Set
- X: Not set or may be set according to the malfunctioning part when one side of the CAN bus wire opens
- Skid Control ECU Communication Stop Mode (Click here)
- Steering Angle Sensor Communication Stop Mode (Click here)
- Yaw Rate Sensor Communication Stop Mode (Click here)
- Gateway ECU Communication Stop Mode (Click here)
- ECM Communication Stop Mode (Click here)
- Main Body ECU Communication Stop Mode (Click here)
- Center Airbag Sensor Communication Stop Mode (Click here)
- Combination Meter ECU Communication Stop Mode (Click here)
- Air Conditioning Amplifier Communication Stop Mode (Click here)
- ○: Set