PROBLEM SYMPTOMS TABLE
Troubleshooting · Vehicles built Oct 2006 – May 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
- HINT:
- Before inspecting the suspected areas listed in the table below, check the fuse and relay.
- Methods used to verify the cause of the problem are listed in order of probability in the suspected area column.
- Before inspecting the suspected areas listed in the table below, check the fuse and relay.
| Symptom |
Suspected Area |
See page |
| Pressing power switch does not turn on system. |
1. Proceed to "Pressing Power Switch does not Turn on System" |
Click here
|
| 2. Radio receiver power source circuit |
Click here
|
|
| 3. Radio receiver (for 2GR-FE RHD) |
Click here
|
|
| 4. Radio receiver (for Except 2GR-FE RHD) |
Click here
|
|
| Panel switch does not function. |
1. Steering pad switch circuit (*1) |
Click here
|
| 2. Radio receiver (for 2GR-FE RHD) |
Click here
|
|
| 3. Radio receiver (for Except 2GR-FE RHD) |
Click here
|
|
| No sound can be heard from speakers. (Audio is mute.) |
1. Radio receiver power source circuit |
Click here
|
| 2. Proceed to "No Sound can be Heard from Speakers" |
Click here
|
|
| 3. Speaker circuit |
Click here
|
|
| 4. Radio receiver (for 2GR-FE RHD) |
Click here
|
|
| 5. Radio receiver (for Except 2GR-FE RHD) |
Click here
|
|
| Sound quality is bad in all modes. (Volume is too low.) |
1. Proceed to "Poor Sound Quality in All Modes (Low Volume)" |
Click here
|
| 2. Speaker circuit |
Click here
|
|
| 3. Radio receiver (for 2GR-FE RHD) |
Click here
|
|
| 4. Radio receiver (for Except 2GR-FE RHD) |
Click here
|
|
| ASL does not function. (*1) |
Proceed to "Vehicle Speed Signal between Radio Receiver and Combination Meter" |
Click here
|
| Abnormal noise occurs. |
1. Proceed to "Noise Occurs" |
Click here
|
| 2. Radio receiver (for 2GR-FE RHD) |
Click here
|
|
| 3. Radio receiver (for Except 2GR-FE RHD) |
Click here
|
|
| Radio broadcast cannot be received or poor reception. |
Proceed to "Radio Broadcast cannot be Received or Poor Reception" |
Click here
|
| CD cannot be inserted / played or CD is ejected right after insertion. (*1) |
1. Radio receiver power source circuit |
Click here
|
| 2. Proceed to "CD cannot be Inserted / Played or CD is Ejected Right After Insertion" |
Click here
|
|
| CD cannot be ejected. (*1) |
1. Radio receiver power source circuit |
Click here
|
| 2. Proceed to "CD cannot be Ejected" |
Click here
|
|
| Sound quality is bad only when CD is played. (Volume is too low.) (*1) |
Proceed to "Sound Quality is Bad Only when CD is Played (Volume is Too Low)" |
Click here
|
| CD sound skips. (*1) |
Proceed to "CD Sound Skips" |
Click here
|
| Radio receiver cannot be illuminated at night. |
1. Illumination circuit |
Click here
|
| 2. Radio receiver (for 2GR-FE RHD) |
Click here
|
|
| 3. Radio receiver (for Except 2GR-FE RHD) |
Click here
|
|
| Cassette tape cannot be inserted or played. (*2) |
1. Radio receiver power source circuit |
Click here
|
| 2. Proceed to "Cassette Tape cannot be Inserted or Played" |
Click here
|
|
| Cassette tape cannot be ejected. (*2) |
1. Radio receiver power source circuit |
Click here
|
| 2. Proceed to "Cassette Tape cannot be Ejected" |
Click here
|
|
| Sound quality is bad only when playing tape. (*2) |
Proceed to "Sound Quality is Bad Only when Playing Tape" |
Click here
|
| Tape is tangled due to incorrect tape speed or auto-reverse malfunction. (*2) |
Proceed to "Tape is Tangled due to Incorrect Tape Speed or Auto-Reverse Malfunction" |
Click here
|
| Symptom |
Suspected Area |
See page |
| Audio system cannot be operated with steering pad switch. |
1. Steering pad switch circuit |
Click here
|
| 2. Radio receiver (for 2GR-FE RHD) |
Click here
|
|
| 3. Radio receiver (for Except 2GR-FE RHD) |
Click here
|
|
| Steering pad switch cannot be illuminated at night. |
1. Illumination circuit |
Click here
|
| 2. Radio receiver (for 2GR-FE RHD) |
Click here
|
|
| 3. Radio receiver (for Except 2GR-FE RHD) |
Click here
|
- *1: w/ CD Player
- *2: w/o CD Player