Engine Coolant Temperature Receiver Gauge Malfunction
Circuit diagnosis · Vehicles built Jun 2006 – Sep 2006
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
The meter CPU receives engine coolant temperature signals from the ECM via the CAN communication lines (CAN No. 1 Bus). The meter CPU displays engine coolant temperature that is calculated based on the data received from the ECM.WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- If there is an open or short in the engine coolant temperature sensor circuit, the ECM outputs the DTCs. Perform troubleshooting with the "SFI System" (Click here).
| 1. CHECK CAN COMMUNICATION SYSTEM |
Check if CAN communication DTC is output (Click here for LHD, Click here for RHD).
- Result:
Result
Proceed to
CAN communication DTC is not output.
A
CAN communication DTC is output.
B (Click here for LHD, Click here for RHD)
|
|
||||
| A | |
| 2. PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester on.
Enter the following menus: Body / Combination Meter / Active Test.
Check the operation by referring to the operation in the table below.
Combination Meter: Tester Display
Test Part
Control Range
Normal Condition
Water Temperature Meter Operation
Engine coolant temperature receiver gauge
Low, Normal, High
-
- OK:
- Needle indication is normal.
|
|
||||
| OK | |
| 3. READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester on.
Enter the following menus: Body / Combination Meter / Data List.
*1: Except for G.C.C. Countries*2: for G.C.C. CountriesCombination Meter: Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Coolant Temperature
Engine coolant temperature/Min: 0°C (32°F), Max.: 127.5°C (261.5°F)
After warming up: 78 to 105°C (172 to 221°F) (*1)
- If -40°C (-40°F): sensor circuit open
- If 140°C (284°F) or more: sensor circuit shorted
After warming up: 95 to 105°C (203 to 221°F) (*2)
- OK:
- Engine coolant temperature value displayed on the tester is almost the same as needle indication.
- If -40°C (-40°F): sensor circuit open
|
|
||||
| OK | |
| 4. READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester on.
Enter the following menus: Power train / Engine / Data List.
Check the values by referring to the values in the table below.
Engine: Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Coolant Temp
Engine coolant temperature: -40°C (-40°F) to 140°C (284°F)
After warming up:
80 to 100°C (176 to 212°F)
- If -40°C (-40°F): sensor circuit open
- If 140°C (284°F) or more: sensor circuit shorted
- OK:
- Engine coolant temperature value displayed on the tester is almost the same as needle indication.
- If -40°C (-40°F): sensor circuit open
|
|
||||
| OK | |
| 5. REPLACE COMBINATION METER ASSEMBLY |
Replace the combination meter assembly with a new or a normal one.
- OK:
- The operation of the combination meter assembly returns to normal.
|
|
||||
| OK | ||
| ||
