DTC output mode is set by connecting terminals TC and CG of the DLC3. DTCs are displayed by blinking of the SRS warning light.
HINT:
When each warning light stays blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU is suspected.
A DTC output mode signal is transmitted through CAN communication system to each ECU including the center airbag sensor assembly. Thus when all systems do not enter DTC output mode, there may be an ECM malfunction.
WIRING DIAGRAM
INSPECTION PROCEDURE
1. CHECK CAN COMMUNICATION SYSTEM
Use the intelligent tester to check if the CAN communication system is functioning normally.
HINT:
The center airbag sensor assembly is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.
Refer to the "Bus Check" for CAN communication system.
Click here for LHD with Smart Entry and Start System
Click here for LHD without Smart Entry and Start System
Click here for RHD with Smart Entry and Start System
Click here for RHD without Smart Entry and Start System
Result:
Condition
Proceed to
DTC is not output
A
DTC is output
B
B
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS
A
2. CHECK WIRE HARNESS (TC OF DLC3 - TC OF ECM)
Turn the ignition switch off.
Disconnect the connector from the ECM.
Measure the resistance according to the value(s) in the table below.
Standard resistance:
for 2GR-FE LHD:
Tester Connection
Condition
Specified Condition
E10-13 (TC) - A55-27 (TC)
Always
Below 1 Ω
for 2GR-FE RHD and 2AZ-FE:
Tester Connection
Condition
Specified Condition
E10-13 (TC) - A24-27 (TC)
Always
Below 1 Ω
NG
REPAIR OR REPLACE WIRE HARNESS (TC OF DLC3 - TC OF ECM)
OK
3. CHECK WIRE HARNESS (CG OF DLC3 - BODY GROUND)
Measure the resistance according to the value(s) in the table below.
Standard resistance:
Tester Connection
Condition
Specified Condition
E10-4 (CG) - Body ground
Always
Below 1 Ω
NG
REPAIR OR REPLACE WIRE HARNESS (CG OF DLC3 - BODY GROUND)
OK
4. CHECK WIRE HARNESS (TC OF ECM - BODY GROUND)
Measure the resistance according to the value(s) in the table below.
Standard resistance:
for 2GR-FE LHD:
Tester Connection
Condition
Specified Condition
A55-27 (TC) - Body ground
Always
1 MΩ or higher
for 2GR-FE RHD and 2AZ-FE:
Tester Connection
Condition
Specified Condition
A24-27 (TC) - Body ground
Always
1 MΩ or higher
Result:
Result
Proceed to
NG
A
OK (for 2GR-FE RHD)
B
OK (except 2GR-FE RHD)
C
B
REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)
C
REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)