2006-2011 Camry Aurion · Service Manual BRAKE

ABS Warning Light Remains ON

Circuit diagnosis · Vehicles built Jun 2006 – Sep 2006

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

The skid control ECU sends the indicator signals to the combination meter assembly via the CAN communication system.
If any of the following is detected, the ABS warning light remains on.
  1. The skid control ECU connectors are disconnected from the skid control ECU.
  2. There is a malfunction in the skid control ECU internal circuit.
  3. There is an open in the wire harness between the combination meter and the skid control ECU.
  4. The ABS and/or EBD is defective.

HINT:
The intelligent tester may not be used when the skid control ECU is abnormal.


WIRING DIAGRAM

C145720E01

INSPECTION PROCEDURE

HINT:
Check the condition of each related circuit before troubleshooting (Click here).


1. INSPECT CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).

    Result:
    Condition
    Proceed to
    CAN communication system DTC is not output
    A
    CAN communication system DTC is output
    B



B
INSPECT CAN COMMUNICATION SYSTEM (Click here)
A


2. CHECK SKID CONTROL ECU CONNECTOR SECURELY CONNECTED
  1. Check if the skid control ECU connector is connected.

    OK:
    The connector is securely connected.



NG
CONNECT CONNECTOR TO ECU CORRECTLY
OK


3. CHECK BATTERY
  1. Check the battery voltage.

    Standard voltage:
    11 to 14 V



NG
INSPECT CHARGING SYSTEM
OK


4. INSPECT SKID CONTROL ECU CONNECTOR (IG1 TERMINAL VOLTAGE)

  1. C131970E07
    Disconnect the skid control ECU connector.

  1. Turn the ignition switch to the ON position.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    A25-18 (IG1) - Body ground
    Ignition switch ON
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (IG1 CIRCUIT)
OK


5. INSPECT SKID CONTROL ECU CONNECTOR (GND TERMINAL CONTINUITY)

  1. C131970E05
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    A25-4 (GND1) - Body ground
    Below 1 Ω
    A25-1 (GND2) - Body ground
    Below 1 Ω

  1. Connect the connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (GND CIRCUIT)
OK


6. INSPECT COMBINATION METER ASSEMBLY
  1. Connect the intelligent tester to the DLC3.

  1. Select the "Active Test" on the tester (Click here).

    Active Test: ABS 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    ABS Warning Lamp
    ABS warning light
    Warning light ON / OFF
    Observe combination meter

  1. Check the ABS warning light operation.

    OK:
    The ABS warning light turns on or off in accordance with the intelligent tester.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)


← U0073/94 Control Module Communication Bus OFF (from Jun 2009)ABS Warning Light Remains ON (Oct 2006 – May 2009) →