Brake Warning Light does not Come ON
Circuit diagnosis · Vehicles built from Jun 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
WIRING DIAGRAM








INSPECTION PROCEDURE
- HINT:
- Check the condition of each related circuit connector before troubleshooting (Click here).
| 1. INSPECT CAN COMMUNICATION SYSTEM |
 |
Check if a CAN communication system DTC is output (Click here).
- Result:
Condition
|
Proceed to
|
CAN communication system DTC is not output
|
A
|
CAN communication system DTC is output
|
B
|
|
B |
 |
|
| REPAIR CAN COMMUNICATION SYSTEM |
|
|
| A |
|
 |
|
| 2. INSPECT BRAKE WARNING LIGHT |
 |
- HINT:
- When disconnecting the skid control ECU connector, the brake warning light comes on.
Turn the ignition switch off.
Disconnect the skid control ECU connector.
Turn the ignition switch to the ON position.
Check that the brake warning light comes on.
- OK:
- The brake warning light comes on.
|
NG |
 |
|
|
|
| OK |
|
 |
|
|
| 3. INSPECT COMBINATION METER ASSEMBLY |
 |
Connect the intelligent tester to the DLC3.
Select the "Active Test" on the tester (Click here).
Active Test: ABS
Tester Display
|
Test Part
|
Control Range
|
Diagnostic Note
|
Brake Warning Lamp
|
Brake warning light
|
Warning light ON/OFF
|
Observe combination meter
|
Check the ABS warning light operation.
- OK:
- The brake warning light turns on or off in accordance with the intelligent tester.
|
NG |
 |
|
| REPLACE COMBINATION METER ASSEMBLY |
|
|
| OK |
|
 |
|
|