2006-2011 Camry Aurion · Service Manual TRANSMISSION

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Oct 2006 – May 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

HINT:
  1. The ECM of this system is connected to the CAN and multiplex communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN and multiplex communication systems.
  2. The intelligent tester can be used at steps 3, 4, 6, and 9.


1.Vehicle Brought to Workshop
    NEXT

    2.Customer Problem Analysis
      NEXT

      3.Connect the intelligent tester to DLC3
        NEXT

        4.Check and Clear DTCs and Freeze Frame Data

          HINT:
          (Click here).

        NEXT

        5.Visual Inspection
          NEXT

          6.Setting the Check Mode Diagnosis

            HINT:
            (Click here).

          NEXT

          7.Problem Symptom Confirmation

            HINT:
            (Click here).


          .

          .
          8.Symptom Simulation

            HINT:
            (Click here).

          NEXT

          9.DTC Check

            HINT:
            (Click here).


          .

          .
          10.Basic Inspection

            HINT:
            (Click here, Click here and Click here).


          NG.
          OK

          11.Mechanical System Test

            HINT:
            (Click here).


          NG.
          OK

          12.Hydraulic Test

            HINT:
            (Click here).


          NG.
          OK

          13.Manual Shifting Test

            HINT:
            (Click here).


          NG.
          OK

          14.Problem Symptoms Table Chapter 1

            HINT:
            (Click here).


          NG.
          OK

          15.Problem Symptoms Table Chapter 2

            HINT:
            (Click here).

          NEXT

          16.Part Inspection

            .
            17.DTC Chart

              HINT:
              (Click here).

            NEXT

            18.Circuit Inspection
              NEXT

              19.Repair or Replace
                NEXT

                20.Confirmation Test
                  NEXT

                  ← HOW TO PROCEED WITH TROUBLESHOOTING (Jun 2006 – Sep 2006)HOW TO PROCEED WITH TROUBLESHOOTING (from Jun 2009) →