PROBLEM SYMPTOMS TABLE
Troubleshooting · Vehicles built Oct 2006 – May 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
| Symptom |
Suspected Area |
See page |
| The result of "HOW TO PROCEED WITH TROUBLESHOOTING" is "Open in CAN Main Bus Wire" |
Open in CAN Main Bus Wire |
Click here
|
| The result of "HOW TO PROCEED WITH TROUBLESHOOTING" is "Short in CAN Bus Wires" |
Short in CAN Bus Wires |
Click here
|
| The result of "HOW TO PROCEED WITH TROUBLESHOOTING" is "Short to B+ in CAN Bus Wire" |
Short to B+ in CAN Bus Wire |
Click here
|
| The result of "HOW TO PROCEED WITH TROUBLESHOOTING" is "Short to GND in CAN Bus Wire" |
Short to GND in CAN Bus Wire |
Click here
|
| The result of "HOW TO PROCEED WITH TROUBLESHOOTING" is "Open in One Side of CAN Sub Bus Wire" |
Open in One Side of CAN Branch Wire |
Click here
|
| Symptom |
Suspected Area |
See page |
| "ABS/VSC/TRAC" is not displayed on the intelligent tester (with VSC) |
Skid Control ECU Communication Stop Mode |
Click here
|
| "A/C" is not displayed on the intelligent tester |
Air Conditioning Amplifier Communication Stop Mode |
Click here
|
| "Body/Gateway" is not displayed on the intelligent tester |
Main Body ECU Communication Stop Mode |
Click here
|
| "Steering Angle Sensor" is not displayed on the intelligent tester |
Steering Angle Sensor Communication Stop Mode |
Click here
|
| "Yaw Rate/Deceleration Sensor" is not displayed on the intelligent tester |
Yaw Rate Sensor Communication Stop Mode |
Click here
|
| "Engine" is not displayed on the intelligent tester |
ECM Communication Stop Mode |
Click here
|
| "Meter" is not displayed on the intelligent tester |
Combination Meter Communication Stop Mode |
Click here
|
| "SRS Airbag" is not displayed on the intelligent tester |
Center Airbag Sensor Communication Stop Mode |
Click here
|